Nissan Murano Z51. Manual — part 1188
RF-92
< PRECAUTION >
PRECAUTIONS
If turning the steering wheel is required with the battery disconnected or discharged, follow the operation pro-
cedure below before starting the repair operation.
OPERATION PROCEDURE
1.
Connect both battery cables.
NOTE:
Supply power using jumper cables if battery is discharged.
2.
Turn the push-button ignition switch to ACC position.
(At this time, the steering lock will be released.)
3.
Disconnect both battery cables. The steering lock will remain released with both battery cables discon-
nected and the steering wheel can be turned.
4.
Perform the necessary repair operation.
5.
When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn
the push-button ignition switch from ACC position to ON position, then to LOCK position. (The steering
wheel will lock when the push-button ignition switch is turned to LOCK position.)
6.
Perform self-diagnosis check of all control units using CONSULT-III.
FOR MEXICO : Precaution for Procedure without Cowl Top Cover
INFOID:0000000005716202
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
PIIB3706J
PREPARATION
RF-93
< PREPARATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000005516862
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tool
INFOID:0000000005516863
Tool number
(Kent-Moore No.)
Tool name
Description
(J39570)
Chassis ear
Locates the noise
(J43980)
NISSAN Squeak and Rattle
Kit
Repairs the cause of noise
SIIA0993E
SIIA0994E
Tool name
Description
Engine ear
Locates the noise
Remover tool
Removes the clips, pawls and metal clips
SIIA0995E
JMKIA3050ZZ
RF-94
< REMOVAL AND INSTALLATION >
GLASS LID
REMOVAL AND INSTALLATION
GLASS LID
Exploded View
INFOID:0000000005516864
1.
Roof side finisher RH
2.
Rear link cover
3.
TORX bolt
4.
Glass lid
5.
Roof side finisher LH
6.
Inner blind
7.
Sunroof unit assembly
8.
Sunroof bracket
9.
Drain hose
10. Drain connector
11.
Drain plug
12. Sunroof motor assembly
JMKIA1901ZZ
GLASS LID
RF-95
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
Removal and Installation
INFOID:0000000005516865
REMOVAL
CAUTION:
Always work with a helper.
1.
Remove the roof rail assembly. Refer to
EXT-29, "Removal and Installation"
2.
Remove the roof side finisher.
Remove the clips, and then pull out roof side finisher.
3.
Half open the glass lid.
4.
Remove the TORX bolts from inner side.
• Remove the inner blind.
• Remove the TORX bolts (A).
5.
Remove the TORX bolts from outer side.
• Remove the pawls, and then pull down rear link cover (1).
13. Sunshade motor assembly
Refer to
: Clip
JMKIA1904ZZ
JMKIA1905ZZ
: Pawl
JMKIA1906ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст