Nissan Murano Z51. Manual — part 479
DLN-50
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
AWD CONTROL UNIT
REMOVAL AND INSTALLATION
AWD CONTROL UNIT
Exploded View
INFOID:0000000005514208
Removal and Installation
INFOID:0000000005514209
REMOVAL
1.
Remove instrument lower panel LH. Refer to
2.
Remove Knee protector (1).
3.
Disconnect AWD control unit harness connector.
4.
Remove AWD control unit mounting bolts.
5.
Remove AWD control unit (1).
INSTALLATION
1.
AWD control unit
: Vehicle front
JPDIE0051ZZ
: Bolt
JSGIA0306ZZ
JPDIE0054ZZ
AWD CONTROL UNIT
DLN-51
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
Install in the reverse order of removal.
DLN-52
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
SIDE OIL SEAL
SIDE OIL SEAL
Exploded View
INFOID:0000000005514210
Removal and Installation
INFOID:0000000005514211
REMOVAL
NOTE:
Transaxle side oil seal is attached to transaxle assembly. Replace it when transfer assembly is removed from
vehicle.
1.
Remove front drive shaft (right side). Refer to
.
CAUTION:
Be careful not to damage gear oil seal inside of transfer.
2.
Remove side oil seal with a suitable tool.
CAUTION:
Be careful not to damage adapter case.
INSTALLATION
1.
Transfer assembly
2.
Side oil seal
A.
Oil seal lip
:Vehicle front
:Apply multi-purpose grease.
Refer to
for symbols not described on the above.
JPDIE0020ZZ
JPDIE0018ZZ
SIDE OIL SEAL
DLN-53
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
1.
Apply multi-purpose grease to side oil seal lips. As shown in the
figure, install side oil seal so that it becomes flush with the case
end surface, using the drift (A) [SST: KV38101700 ( — )].
CAUTION:
• Never reuse side oil seal.
• Be careful not to incline side oil seal.
2.
Install front drive shaft (right side). Refer to
.
CAUTION:
Be careful not to damage gear ring oil seal inside of trans-
fer.
3.
Check oil level and leakage. Refer to
JPDIE0019ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст