Nissan Titan A60. Manual — part 872
SRC-4
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
>> GO TO 3
3.
TECHNICAL SERVICE BULLETINS
Check for technical service bulletins.
>> GO TO 4
4.
USER MODE
Perform self-diagnosis using the AIR BAG warning lamp in User mode. Refer to
.
>> GO TO 5
5.
SELF-DIAGNOSIS
Perform SELF-DIAGNOSIS. Refer to
SRC-60, "Trouble Diagnosis with CONSULT-III"
(w/CONSULT-III) or
SRC-62, "Trouble Diagnosis without CONSULT-III"
(w/o CONSULT- III).
>> GO TO 6
6.
REPLACE PART
Replace the malfunctioning part.
>> GO TO 7
7.
FINAL CHECK
Check SRS using Diagnosis mode and User mode.
Does Diagnosis mode and User mode indicate SRS normal?
YES
>> Inspection end.
NO
>> GO TO 5
INTERMITTENTS INCIDENT
SRC-5
< BASIC INSPECTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
INTERMITTENTS INCIDENT
Inspection Procedure
INFOID:0000000006163123
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being detected currently. This DTC will not be
detected on SELF DIAG [CURRENT], but may be viewed on SELF DIAG [PAST] using CONSULT-III.
Trouble Diagnosis with CONSULT-III
INFOID:0000000006163124
DIAGNOSTIC PROCEDURE 4
Check SRS Repair History
1.
CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR
Check repair history of the SRS.
Have any previous repairs been made to the SRS?
Yes
>> Self-diagnostic result SELF-DIAG [PAST] (previously stored in the memory) might not be erased
after repair. Go to DIAGNOSTIC PROCEDURE 3. Refer to
SRC-15, "Self-Diagnosis Function
.
No
>> Go to DIAGNOSTIC PROCEDURE 2. Refer to
SRC-6
< SYSTEM DESCRIPTION >
SRS AIR BAG SYSTEM
SYSTEM DESCRIPTION
SRS AIR BAG SYSTEM
SRS Configuration
INFOID:0000000006163125
The air bag deploys if the air bag diagnosis sensor unit is activated while the ignition switch is in the ON or
START position.
The collision modes for which supplemental restraint systems are activated are different among the SRS sys-
tems. For example, the driver air bag module, front passenger air bag module and front seat belt pre-tension-
ers are activated in a frontal collision but not in a side collision.
SRS configurations for some collision modes are as follows:
WHIA0186E
SRS configuration
Frontal collision
Left side collision
Right side collision
Rollover
Driver air bag module
×
—
—
—
Front passenger air bag module
×
—
—
—
Front LH seat belt pre-tensioner
×
—
—
×
Front RH seat belt pre-tensioner
×
—
—
×
Front LH side air bag module
—
×
—
—
Front RH side air bag module
—
—
×
—
LH side curtain air bag module
—
×
—
×
RH side curtain air bag module
—
—
×
×
SRS AIR BAG SYSTEM
SRC-7
< SYSTEM DESCRIPTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
SRS Component Parts Location
INFOID:0000000006163126
Driver Air Bag Module
INFOID:0000000006163127
The driver air bag module is dual stage and located in the steering
wheel assembly. It operates with the SRS system in a frontal colli-
sion exceeding a specified level.
1.
Side curtain air bag modules
2.
Front RH side air bag module
3.
RH side air bag (satellite) sensor
4.
Front RH seatbelt pre-tensioner
5.
Belt tension sensor
6.
Occupant classification system sensor
7.
Occupant classification system con-
trol unit
8.
Front passenger air bag off indi-
cator
9.
Front passenger air bag module
10. Crash zone sensor
11. Air bag warning lamp
12. Spiral cable
13. Driver air bag module
14. Front LH seatbelt pre-tensioner 15. LH side air bag (satellite) sensor
16. Front LH side air bag module
17. Air bag diagnosis sensor unit
WHIA0221E
WHIA0325E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст