Nissan Titan A60. Manual — part 960
TM-228
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
17. Remove mid carrier assembly from rear carrier assembly.
18. Remove needle bearing (front side) from mid carrier assembly.
19. Remove needle bearing (rear side) from mid carrier assembly.
20. Remove bearing race from rear carrier assembly.
21. Remove needle bearing from rear carrier assembly.
SCIA5697E
SCIA2805E
SCIA2804E
SCIA5175E
SCIA2803E
DISASSEMBLY
TM-229
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
22. Remove mid sun gear assembly, rear sun gear assembly and
high and low reverse clutch hub as a unit.
CAUTION:
Remove them with bearing race and needle bearing.
23. Remove high and low reverse clutch assembly from direct clutch
assembly.
CAUTION:
Make sure that needle bearing is installed to the high and
low reverse clutch assembly edge surface.
24. Remove needle bearing from drum support.
25. Remove direct clutch assembly from reverse brake.
26. Remove snap ring from A/T assembly harness connector.
SCIA5018E
SCIA2306E
SCIA5198E
SCIA5019E
SCIA5021E
TM-230
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
27. Push A/T assembly harness connector.
CAUTION:
Do not damage connector.
28. Remove oil pan and oil pan gasket. Refer to
29. Check foreign materials in oil pan to help determine causes of
malfunction. If the A/T fluid is very dark, smells burned, or con-
tains foreign particles, the frictional material (clutches, band)
may need replacement. A tacky film that will not wipe clean indi-
cates varnish build up. Varnish can cause valves, servo, and
clutches to stick and can inhibit pump pressure.
• If frictional material is detected, perform A/T fluid cooler
cleaning. Refer to
TM-172, "A/T Fluid Cooler Cleaning"
30. Remove magnets from oil pan.
31. Disconnect output speed sensor connector (1).
CAUTION:
Do not damage connector.
SCIA5022E
SCIA5199E
SCIA5200E
JSDIA1319ZZ
DISASSEMBLY
TM-231
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
32. Straighten terminal clip (
) to free output speed sensor har-
ness.
33. Remove bolts (A), (B) and (C) from control valve with TCM.
•
: Front
34. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.
35. Remove plug (1) with bracket (2) from control valve with TCM.
36. Remove bracket (1) from plug (2).
JSDIA1320ZZ
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8077E
SCIA5260E
JSDIA1311ZZ
JSDIA1312ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст