Nissan Titan A60. Manual — part 544
FRONT SUSPENSION ASSEMBLY
FSU-13
< REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
REMOVAL AND INSTALLATION
FRONT SUSPENSION ASSEMBLY
Component
INFOID:0000000006161672
1.
Dust cover
2.
Shock absorber
3.
Upper link
4.
Steering knuckle
5.
Cotter pin
6.
Bolt
7.
Jounce bumper
8.
Washer
9.
Lower link
10. Stabilizer bar
11. Stabilizer bar bushing
12. Stabilizer bar mounting bracket
13. Connecting rod
14. Coil spring
15. Upper seat
16. Upper spring seat
17. Shock absorber bushing
18. Shock absorber mounting insulator
19. Spacer
20. Washer
Front
AWEIA0142GB
FSU-14
< UNIT REMOVAL AND INSTALLATION >
KNUCKLE
UNIT REMOVAL AND INSTALLATION
KNUCKLE
Removal and Installation
INFOID:0000000006161673
REMOVAL
1. Remove wheel hub and bearing assembly. Refer to
FAX-6, "Removal and Installation"
.
• Disconnect wheel sensor harness connector. Do not remove wheel sensor from wheel hub and bearing
assembly for this procedure.
2. Remove steering outer socket from steering knuckle using Tool.
CAUTION:
• Be careful not to damage ball joint boot.
• Temporarily tighten nut to prevent damage to threads and
to prevent Tool from coming off.
3. Remove cotter pin and nut from upper link ball joint and discard the cotter pin.
4. Separate upper link ball joint from steering knuckle using Tool.
1.
Disc rotor
2.
Wheel hub and bearing assembly
3.
Wheel stud
4.
Splash guard
5.
Steering knuckle
Front
AWDIA0423GB
Tool number
: HT72520000 (J-25730-A)
WGIA0130E
Tool number
: ST29020001 (J-24319-01)
LEIA0095E
KNUCKLE
FSU-15
< UNIT REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
5. Remove the stabilizer bar connecting rod lower nut using a power tool, then separate the connecting rod
from the lower link. Refer to
FSU-19, "Removal and Installation"
6. Remove pinch bolt from steering knuckle using power tool, then
separate lower link ball joint from steering knuckle.
7. Remove steering knuckle from vehicle.
INSPECTION AFTER REMOVAL
Check for deformity, cracks and damage on each part, replace if necessary.
• Perform ball joint inspection. Refer to
.
INSTALLATION
Installation is in the reverse order of removal.
• Refer to
for tightening torques.
CAUTION:
Use a new cotter pin for installation of lock nut.
• When installing disc rotor on wheel hub and bearing assembly,
align the marks.
NOTE:
When not using the alignment mark, refer to
• When installing wheel and tire, refer to
LEIA0097E
WDIA0044E
FSU-16
< UNIT REMOVAL AND INSTALLATION >
UPPER BALL JOINT AND LOWER BALL JOINT
UPPER BALL JOINT AND LOWER BALL JOINT
Removal and Installation
INFOID:0000000006161674
The ball joints are part of the upper and lower links. Refer to
FSU-18, "Removal and Installation"
FSU-17, "Removal and Installation"
(lower link).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст