Nissan Titan A60. Manual — part 531
EXT-30
< REMOVAL AND INSTALLATION >
SIDE GUARD MOLDING
• To re-use existing molding, clean all traces of double sided tape from the molding and apply new double-
faced tape to the molding.
1. Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
2. Heat the panel and molding tape surface to 30
° to 40°C (86° to 104°F).
3. Remove the backing sheet from the tape surface.
• Align the locating pin into the hole in the outer door.
• Continue aligning the pins into their corresponding holes in the outer door during installation.
4. Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press molding to door surface.
• Apply even pressure along molding to insure proper wet out.
CAUTION:
To secure contact, do not wash vehicle for 24 hours after installation.
BED RAILS AND TRIM
EXT-31
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
BED RAILS AND TRIM
Removal and Installation
INFOID:0000000006163345
1.
Header top trim
2.
Header tie down rail
3.
Rope hook
4.
Tie down cleat
5.
Floor rail cover LH
6.
Floor rail LH
7.
Bed side front tie down rail LH
8.
Top side rail trim LH
9.
Bed side rear tie down rail LH
AWKIA1529GB
EXT-32
< REMOVAL AND INSTALLATION >
BED RAILS AND TRIM
REMOVAL
1. Remove floor rail covers.
2. Remove tie down cleats.
3. Remove floor rails LH/RH.
4. Remove bed side front and rear tie down rails LH/RH.
5. Remove rope hooks.
6. Remove header tie down rail.
7. Release clips and remove header top trim.
8. Release clips and remove top side rail trim LH/RH.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
Tighten rail bolts in numerical order.
10. Floor rail RH
11. Floor rail cover RH
12. Bed side rear tie down rail RH
13. Top side rail trim RH
14. Bed side front tie down rail RH
15. Bolt
16. Washer
17
Spacer
18. Weld nut
19. Plastic keeper
20. Rail
TAIL GATE FINISHER
EXT-33
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
TAIL GATE FINISHER
Removal and Installation
INFOID:0000000006163346
REMOVAL
1. Release clips and remove tailgate top protector.
2. Remove screws and remove tailgate protector (if equipped) and tailgate cover plate.
INSTALLATION
Installation is in the reverse order of removal.
1.
Tailgate protector (if equipped)
2.
Tailgate cover plate
3.
Tailgate top protector
4.
Tailgate assembly
AWKIA1320ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст