Nissan Versa Note. Manual — part 864
C1704, C1705, C1706, C1707 LOW TIRE PRESSURE
WT-25
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
DTC/CIRCUIT DIAGNOSIS
C1704, C1705, C1706, C1707 LOW TIRE PRESSURE
DTC Logic
INFOID:0000000009443175
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
1. Turn the ignition switch ON.
2. Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1704”, “C1705”, “C1706”, or “C1707” detected?
YES
>> Proceed to
.
NO
>> Inspection End.
Diagnosis Procedure
INFOID:0000000009443176
1.
CHECK DATA MONITOR
With CONSULT
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.
4. Within 5 minutes after vehicle stopped, check that the tire pressures are within specification. Refer to
.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Repair or replace error-detected parts.
DTC
Display item
Malfunction detected condition
Possible causes
C1704
LOW PRESSURE FL
Front LH tire pressure drops to 182.7 kPa (1.9 kg/cm
2
, 26 psi) or less.
Low tire pressure
C1705
LOW PRESSURE FR
Front RH tire pressure drops to 182.7 kPa (1.9 kg/cm
2
, 26 psi) or less.
C1706
LOW PRESSURE RR
Rear RH tire pressure drops to 182.7 kPa (1.9 kg/cm
2
, 26 psi) or less.
C1707
LOW PRESSURE RL
Rear LH tire pressure drops to 182.7 kPa (1.9 kg/cm
2
, 26 psi) or less.
Monitor item
Displayed value
AIR PRESS FL
Approximately equal to the indication on tire gauge value for front LH tire
AIR PRESS FR
Approximately equal to the indication on tire gauge value for front RH tire
AIR PRESS RR
Approximately equal to the indication on tire gauge value for rear RH tire
AIR PRESS RL
Approximately equal to the indication on tire gauge value for rear LH tire
WT-26
< DTC/CIRCUIT DIAGNOSIS >
C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)
C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)
DTC Logic
INFOID:0000000009443177
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1708”, “C1709”, “C1710” or “C1711” detected?
YES
>> Proceed to
.
NO
>> Inspection End.
Diagnosis Procedure
INFOID:0000000009443178
Regarding Wiring Diagram information, refer to
WT-15, "Wiring Diagram - With Intelligent Key"
1.
CHECK DATA MONITOR
With CONSULT
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.
4. Within 5 minutes after vehicle is stopped, read the values displayed on CONSULT.
Are all tire pressures displayed 0 kPa (psi)?
YES
>> GO TO 2.
NO
>> GO TO 5.
2.
CHECK REMOTE KEYLESS ENTRY RECEIVER POWER CIRCUIT
Check voltage between remote keyless entry receiver connector and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace harness or connectors.
3.
CHECK REMOTE KEYLESS ENTRY RECEIVER SIGNAL CIRCUIT
DTC
Display Item
Malfunction detected condition
Possible causes
C1708
[NO DATA] FL
Tire pressure data signal from the front LH wheel
transmitter cannot be detected.
• Harness or connector connec-
tion malfunction
• Transmitter ID registration in-
complete
• Transmitter malfunction
C1709
[NO DATA] FR
Tire pressure data signal from the front RH wheel
transmitter cannot be detected.
C1710
[NO DATA] RR
Tire pressure data signal from the rear RH wheel
transmitter cannot be detected.
C1711
[NO DATA] RL
Tire pressure data signal from the rear LH wheel
transmitter cannot be detected.
Remote keyless entry receiver
Ground
Voltage
(Approx.)
Connector
Terminal
M94 (with Intelligent Key system)
1
—
Battery voltage
M23 (without Intelligent Key system)
4
C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)
WT-27
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
1. Turn the ignition switch OFF.
2. Disconnect BCM and remote keyless entry receiver connectors.
3. Check continuity between BCM and remote keyless entry receiver connectors.
4. Check continuity between BCM connector and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace the malfunctioning harness or connector.
4.
CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT
Check continuity between BCM and remote keyless entry receiver connectors.
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Repair or replace the malfunctioning harness or connector.
5.
TRANSMITTER ID REGISTRATION
Perform transmitter ID registration. Refer to
Is transmitter ID registration completed?
YES
>> GO TO 6.
NO
>> Replace applicable transmitter. Refer to
WT-46, "Removal and Installation"
.
6.
CHECK TIRE PRESSURE SIGNAL
With CONSULT
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.
4. Within 5 minutes after vehicle stopped, check that the tire pressures are within specification. Refer to
.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Replace the BCM. Refer to
BCS-70, "Removal and Installation"
(with I-Key) or
(without I-Key).
BCM
Remote keyless entry receiver
Continuity
Connector
Terminal
Connector
Terminal
M97 (with Intelligent Key system)
38
M94 (with Intelligent Key system)
2
Yes
M18 (without Intelligent Key system)
20
M23 (without Intelligent Key system)
BCM
—
Continuity
Connector
Terminal
M97 (with Intelligent Key system)
38
Ground
No
M18 (without Intelligent Key system)
20
BCM
Remote keyless entry receiver
Continuity
Connector
Terminal
Connector
Terminal
M97 (with Intelligent Key system)
18
M94 (with Intelligent Key system)
4
Yes
M18 (without Intelligent Key system)
M23 (without Intelligent Key system)
1
Monitor item
Displayed value
AIR PRESS FL
Approximately equal to the indication on tire gauge value for front LH tire
AIR PRESS FR
Approximately equal to the indication on tire gauge value for front RH tire
AIR PRESS RR
Approximately equal to the indication on tire gauge value for rear RH tire
AIR PRESS RL
Approximately equal to the indication on tire gauge value for rear LH tire
WT-28
< DTC/CIRCUIT DIAGNOSIS >
C1716, C1717, C1718, C1719 TRANSMITTER (PRESSURE DATA)
C1716, C1717, C1718, C1719 TRANSMITTER (PRESSURE DATA)
DTC Logic
INFOID:0000000009443179
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
1. Turn the ignition switch ON.
2. Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1716”, “C1717”, “C1718”, or “C1719” detected?
YES
>> Proceed to
.
NO
>> Inspection End.
Diagnosis Procedure
INFOID:0000000009443180
1.
CHECK TIRE PRESSURE
Check the air pressure of all wheels. Refer to pressure observed during “DTC CONFIRMATION PROCE-
DURE”.
Is the inspection result normal?
YES
>> Replace the DTC-detected malfunctioning transmitter. Refer to
.
NO
>> GO TO 2.
2.
CHECK TIRE PRESSURE SIGNAL
With CONSULT
1. Perform transmitter ID registration for all wheels. Refer to
2. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
3. Stop the vehicle.
4. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.
5. Within 5 minutes after vehicle is stopped, read the values displayed on CONSULT.
Are tire pressures displayed as 438.6 kPa (4.47 kg/cm
2
, 63.6 psi)?
YES
>> Replace transmitter for the tire that displayed pressure as 438.6 kPa (4.47 kg/cm
2
, 63.6 psi).
WT-46, "Removal and Installation"
.
NO
>> Perform “DTC CONFIRMATION PROCEDURE” again. Refer to
.
DTC
Display Item
Malfunction detected condition
Possible causes
C1716
[PRESSDATA ERR] FL
Malfunction in the tire pressure data from the
front LH wheel transmitter.
• Transmitter ID registration in-
complete
• Transmitter malfunction
C1717
[PRESSDATA ERR] FR
Malfunction in the tire pressure data from the
front RH wheel transmitter.
C1718
[PRESSDATA ERR] RR
Malfunction in the tire pressure data from the
rear RH wheel transmitter.
C1719
[PRESSDATA ERR] RL
Malfunction in the tire pressure data from the
rear LH wheel transmitter.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст