Nissan Versa Note. Manual — part 731
SIDE CURTAIN AIR BAG MODULE
SR-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
• For removing/installing the side curtain air bag module
harness connector, insert a thin screwdriver wrapped in
tape into the notch, lift the lock and remove the harness
connector as shown.
• Install the harness connector with the lock raised, and
push the lock into the harness connector as shown.
• After installing the harness connector, check that the lock
is pushed in securely.
4. Remove the tether bolt, then the remaining side curtain air bag module bolts.
INSTALLATION
Installation is in the reverse order of removal.
WARNING:
When installing the side curtain air bag module make sure it is not twisted between attachment brack-
ets.
CAUTION:
• Make sure to attach the double stick tape to the tether and adhere it to the pillar.
• Do not damage the harness while installing the side curtain air bag module.
• After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer
PHIA0953J
SR-22
< REMOVAL AND INSTALLATION >
SIDE AIR BAG MODULE
SIDE AIR BAG MODULE
Removal and Installation
INFOID:0000000009423890
The side air bag module is part of the front seatback. Refer to
SE-24, "DRIVER SIDE : Side Air Bag Module"
(DRIVER SIDE) or
SE-25, "PASSENGER SIDE : Side Air Bag Module"
(PASSENGER SIDE).
CRASH ZONE SENSOR
SR-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
CRASH ZONE SENSOR
Exploded View
INFOID:0000000008969290
Removal and Installation
INFOID:0000000008969291
WARNING:
• Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at
least three minutes.
• Replace the crash zone sensor if it has been dropped or sustained an impact.
• Replace the crash zone sensor if either the driver air bag module, the front passenger air bag mod-
ule, or a front seat belt pre-tensioner has been deployed.
• Do not strike the crash zone sensor.
• Do not use air tools or electric tools for servicing.
REMOVAL
1. Disconnect negative and positive battery terminals, then wait at least three minutes. Refer to
"Removal and Installation (Battery)"
.
1. Crash zone sensor
2. Bracket
ALHIA0305ZZ
SR-24
< REMOVAL AND INSTALLATION >
CRASH ZONE SENSOR
2. Remove and discard crash zone sensor nut (A).
CAUTION:
Do not reuse crash zone sensor nut.
3. Remove bracket (1) and crash zone sensor (2).
4. Disconnect the slide double locking type harness connector from the crash zone sensor, as shown.
INSTALLATION
Installation is in the reverse order of removal.
Position the crash zone sensor using the locating pin before tightening the nut to specification.
CAUTION:
• Do not reuse the crash zone sensor nut.
• Do not damage the harness connector during installation.
• After the work is completed, perform diagnosis to check that no malfunction is detected. Refer to
ALHIA0306ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст