Nissan Versa Note. Manual — part 437
SQUEAK AND RATTLE TROUBLE DIAGNOSES
EXT-21
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
Diagnostic Worksheet
INFOID:0000000009671258
LAIA0072E
EXT-22
< SYMPTOM DIAGNOSIS >
SQUEAK AND RATTLE TROUBLE DIAGNOSES
LAIA0071E
FRONT BUMPER
EXT-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
REMOVAL AND INSTALLATION
FRONT BUMPER
Exploded View
INFOID:0000000008969513
1.
Front bumper fascia side bracket
(RH)
2.
Front bumper reinforcement
3.
Active grille shutter (if equipped)
4.
Front energy absorber
5.
Front fascia side deflector
(RH)
6.
Front fog lamp (RH) (if equipped)
7.
Tow cover
8.
Front license plate bracket
9.
Front bumper fascia
10. Front fog lamp (LH) (if equipped) 11. Front bumper finisher
(if equipped)
12. Front fascia side deflector (LH)
13. Front air spoiler
14. Front under cover
15. Front bumper fascia side bracket
(LH)
AWKIA2516ZZ
EXT-24
< REMOVAL AND INSTALLATION >
FRONT BUMPER
Removal and Installation
INFOID:0000000008969514
CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily
substances.
REMOVAL
1. Remove the front grille. Refer to
EXT-29, "Removal and Installation"
2. Remove the four front bumper fascia upper clips.
3. Remove the front under cover. Refer to
EXT-37, "FRONT UNDER COVER : Removal and Installation"
.
4. Partially remove front fender protectors (LH/RH) at the front edge to access front bumper fascia bolts.
5. Remove front bumper fascia bolts (A) (LH/RH).
6. Remove the front bumper fascia from the front bumper fascia
side brackets (LH/RH) by releasing the pawls as shown.
: Pawl
CAUTION:
When removing front bumper fascia, two people are
required to avoid damaging.
7. Disconnect the harness connectors from the front fog lamps (LH/RH) (if equipped).
8. Remove front bumper fascia.
9. Remove the following parts after removing front bumper fascia (if necessary).
• Tow cover
• Front fog lamps (LH/RH) (if equipped). Refer to
EXL-101, "Removal and Installation"
• Front license plate bracket
• Front bumper finisher (if equipped)
10. Remove the active grille shutter (if equipped) (if necessary). Refer to
EXT-31, "Removal and Installation"
(ACTIVE GRILLE SHUTTER).
11. Remove the front energy absorber (if necessary).
12. Remove nuts and front bumper reinforcement (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Tighten the front bumper reinforcement nuts to specification. Refer to
NOTE:
• The following table shows the specified values for checking normal installation specifications.
• Fitting adjustment cannot be performed.
16. Front bumper reinforcement
bracket (RH)
17. Front bumper reinforcement
bracket (LH)
A.
J nut
B.
Front fog lamp bracket
Pawl
JMKIA8017ZZ
AWKIA1890ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст