Nissan Versa Note. Manual — part 536
IP-18
< REMOVAL AND INSTALLATION >
CENTER CONSOLE ASSEMBLY
CENTER CONSOLE ASSEMBLY
Exploded View
INFOID:0000000009405654
TYPE 1
TYPE 2
Removal and Installation
INFOID:0000000009405655
REMOVAL
1. Move shift selector to “N” position (CVT: RE0F11A).
2. Remove shift selector handle (5MT: RS5F91R). Refer to
.
3. Raise parking brake lever.
AWJIA1134ZZ
1.
Shift selector boot (5MT: RS5F91R) 2.
Center console assembly
3.
USB connector (if equipped)
4.
Power socket
A.
Clip
B.
Screw
AWJIA1135ZZ
1.
Shift selector boot (5MT: RS5F91R) 2.
Center console assembly
3.
Power socket
4.
USB connector (if equipped)
5.
Heated seat switch (RH) (if equipped)
6.
Heated seat switch (LH)
(if equipped)
A.
Clip
B.
Screw
CENTER CONSOLE ASSEMBLY
IP-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
4. Remove center console assembly clips (A).
5. Remove the center console assembly rear screws.
6. Slide driver side seat to the full rearward position and recline.
7. Slide passenger side seat to the full rearward position and recline.
8. Lift rear right corner of center console assembly, rotating slightly,
making sure to lift assembly upward over the parking brake han-
dle.
9. Disconnect the harness connectors from the center console
assembly.
10. Remove center console assembly.
INSTALLATION
Installation is in the reverse order of removal.
JMJIA6093ZZ
AWJIA0695ZZ
IP-20
< REMOVAL AND INSTALLATION >
CENTER CONSOLE LOWER
CENTER CONSOLE LOWER
Removal and Installation
INFOID:0000000009405656
REMOVAL
1. Remove center console assembly. Refer to
IP-18, "Removal and Installation"
2. Remove center console lower.
a. Remove center console lower clips (LH/RH) (A).
b. Release center console lower pawls using a suitable tool and
remove.
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
JMJIA6052ZZ
AWJIA0706ZZ
CLUSTER LID A
IP-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
CLUSTER LID A
Removal and Installation
INFOID:0000000009405650
REMOVAL
1. Remove steering column covers. Refer to
IP-17, "Removal and Installation"
.
2. Remove cluster lid C. Refer to
IP-22, "Removal and Installation"
3. Remove cluster lid A.
a. Remove combination meter finisher and cluster lid A as an assembly by pulling rearward to release pawls
and metal clips.
b. Disconnect the harness connector and remove cluster lid A.
c. Separate cluster lid A (2) from combination meter finisher (1) by releasing the metal clips (If necessary).
INSTALLATION
Installation is in the reverse order of removal.
Pawl
Metal clip
AWJIA1075ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст