Nissan Versa Note. Manual — part 141
BRM-16
< REMOVAL AND INSTALLATION >
CORROSION PROTECTION
the new parts. Select an excellent anti-corrosive wax which will penetrate after application and has a long shelf
life.
Undercoating
INFOID:0000000009345080
The underside of the floor and wheelhouse are undercoated to prevent rust, vibration, noise and stone chip-
ping. Therefore, when such a panel is replaced or repaired, apply undercoating to that part. Use an undercoat-
ing which is rust preventive, soundproof, vibration-proof, shock-resistant, adhesive, and durable.
Precautions in Undercoating
1. Do not apply undercoating to any place unless specified (such as the areas above the muffler and three
way catalyst which are subjected to heat).
2. Do not undercoat the exhaust pipe or other parts which become hot.
3. Do not undercoat rotating parts.
4. Apply bitumen wax after applying undercoating.
Indicates anti-corrosive wax coated portions
Front
AWKIA2529ZZ
CORROSION PROTECTION
BRM-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
5. After putting seal on the vehicle, put undercoating on it.
Indicates anti-corrosive wax coated portions
AWKIA2530ZZ
BRM-18
< REMOVAL AND INSTALLATION >
BODY SEALING
BODY SEALING
Description
INFOID:0000000009345081
The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of
sealant and not to allow other unaffected parts to come into contact with the sealant.
AWKIA2531ZZ
BODY SEALING
BRM-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
AWKIA2533ZZ
Front
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст