Nissan Versa Note. Manual — part 38
AV-144
< SYSTEM DESCRIPTION >
[NAVIGATION]
SYSTEM
Front view guiding lines
Rear View
• The rear view image improves the visibility of obstacles in the rear of the vehicle and assists backing and
parking by displaying images from birds-eye view and front side view.
• The rear view image displays the vehicle width guiding line and vehicle distance guiding line, in addition to
the predictive course line according to the steering angle.
NOTE:
The predictive course line is not displayed at the steering neutral position.
• The around view monitor control unit receives the steering angle signal from steering angle sensor via CAN
communication, and controls the direction and distance of the predictive course line.
• ON/OFF setting of predictive course line can be performed using CONSULT.
Rear view guiding lines
Front-Side View
• The front-side view image improves the visibility of obstacles in the front RH side of the vehicle and assists
backing and parking.
• The front-side view image displays the vehicle distance guiding line and vehicle width guiding line.
JSNIA0770GB
JSNIA4567GB
AV
SYSTEM
AV-145
< SYSTEM DESCRIPTION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
Front-side view area and guiding line
Birds-Eye View
• The birds-eye view image improves the visibility of obstacles all around the vehicle and assists backing and
parking.
• The images from the four cameras are converted into an overhead view, and the surroundings of the vehicle
are displayed.
• The blind spot area is displayed on the image to specify the boundary of the four cameras.
Birds-Eye view display image
JSNIA0771GB
AWNIA3141GB
AV-146
< SYSTEM DESCRIPTION >
[NAVIGATION]
SYSTEM
Birds-Eye view display area
AWNIA3142GB
AV
DIAGNOSIS SYSTEM (AV CONTROL UNIT)
AV-147
< SYSTEM DESCRIPTION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DIAGNOSIS SYSTEM (AV CONTROL UNIT)
Description
INFOID:0000000009459993
The AV control unit on board diagnosis performs the functions listed in the table below:
Perform CONSULT diagnosis if the AV control unit on board diagnosis does not start or the screen does not
display anything.
On Board Diagnosis Function
INFOID:0000000009459994
METHOD OF STARTING
1. Turn the ignition ON.
2. Turn the audio system OFF.
Mode
Item
Content
Version
—
Version data of the AV control unit is dis-
played.
User Configuration
Touch Display Calibration
—
Allows correction of the position detec-
tion accuracy of the touch panel.
Radio
FM monitor
—
Monitors the dynamic values of the cur-
rent tuner
AM monitor
—
XM monitor
—
Version data is displayed.
XM functions
• Clear XM Chipset NVM
• Reset All XM Settings
• Clear IGS
• XM CBM Debug Mode
• External Diag Mode
Current status is displayed.
System State
Running System Status
• SD card slot Access
• Power Supply
• Speed Signal
• Direction Signal
• Illumination Signal
• GPS Antenna
• GPS Tracking
• Satellites Visible
• Satellites Tracked
• Microphone Current
• Steering wheel key
• Radio Antenna
• USB Device
• iPod
®
firmware version
The current system status is displayed.
Speaker Test 4kHz
—
This activates a sequence of test tone
outputs to the audio circuits one after the
other for 1 second.
Speaker Test 100Hz
Display-Test
—
This provides a test sequence where
test displays (plain colored display: e.g.
white, black, red, blue, green) are shown
one after the other.
The respective color is shown for an in-
dicated period of time (parameter). After
the display test, the design of the display
previously available is stored. While the
screen shows a plain colored display, a
pixel malfunction may be detected.
Self Test
• SD Card Access
• BT Module Access
• Radio Antenna
• GPS Antenna
• XM Antenna
A system self test is executed and the
results are stored into the error memory.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст