Nissan Frontier D22. Manual — part 44
ASSEMBLY
AT-145
[RL4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
d.
Install O-ring on oil pump assembly.
●
Apply petroleum jelly to O-ring.
e.
Apply petroleum jelly to mating surface of transmission case and
oil pump assembly.
f.
Install oil pump assembly.
●
Install two converter housing securing bolts in bolt holes
in oil pump assembly as guides.
●
Insert oil pump assembly to the specified position in
transmission, as shown at left.
SAT991A
SAT992A
SAT993A
SAT994A
AT-146
[RL4R01A]
ASSEMBLY
6.
Install O-ring on input shaft.
●
Apply ATF to O-rings.
7.
Install converter housing.
a.
Apply Genuine Anaerobic Liquid Gasket or equivalent around
bolt holes in converter housing. Refer to
MENDED CHEMICAL PRODUCTS AND SEALANTS"
.
●
Do not apply too much sealant.
b.
Apply Genuine Anaerobic Liquid Gasket or equivalent to seating
surfaces of bolts that secure front of converter housing. Refer to
GI-42, "RECOMMENDED CHEMICAL PRODUCTS AND SEAL-
ANTS"
c.
Install converter housing on transmission case.
8.
Adjust brake band.
a.
Tighten anchor end pin to specified torque.
b.
Back off anchor end pin two and a half turns.
SAT114B
SAT397C
SAT158G
Anchor end pin
: 4 - 6 N·m (0.4 - 0.6 kg-m, 35 - 52 in-lb)
SAT001B
ASSEMBLY
AT-147
[RL4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
c.
While holding anchor end pin, tighten lock nut.
9.
Install terminal cord assembly.
a.
Install O-ring on terminal cord assembly.
●
Apply petroleum jelly to O-ring.
b.
Compress terminal cord assembly stopper and install terminal
cord assembly on transmission case.
10. Install control valve assembly.
a.
Install accumulator piston return springs B , C and D .
b.
Install manual valve on control valve.
●
Apply ATF to manual valve.
c.
Install control valve assembly on transmission case.
d.
Install connector tube brackets and tighten bolts A and B .
●
Check that terminal assembly harness does not catch.
SAT002B
SAT316I
Free length of return
springs
SAT004BA
SAT005B
Bolt
mm (in)
A
33 (1.30)
B
45 (1.77)
SAT448EA
AT-148
[RL4R01A]
ASSEMBLY
e.
Install O-ring on oil strainer.
●
Apply petroleum jelly to O-ring.
f.
Install oil strainer on control valve.
g.
Securely fasten terminal harness with clips.
11. Install oil pan.
a.
Attach a magnet to oil pan.
b.
Install new oil pan gasket on transmission case.
c.
Install oil pan and bracket on transmission case.
●
Always replace oil pan bolts as they are self-sealing
bolts.
●
Before installing bolts, remove traces of sealant and oil
from mating surface and thread holes.
●
Tighten four bolts in a crisscross pattern to prevent dis-
location of gasket.
d.
Tighten drain plug.
SAT306I
SAT307I
SAT011B
SAT099H
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст