Nissan Frontier D22. Manual — part 128
ASSEMBLY
AT-481
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
c.
Check to be sure that rotation direction of forward clutch assem-
bly is correct.
d.
Install thrust washer onto front of overrun clutch hub.
●
Apply petroleum jelly to the thrust washer.
●
Insert pawls of thrust washer securely into holes in over-
run clutch hub.
e.
Install overrun clutch hub onto rear internal gear assembly.
f.
Install needle bearing onto rear of overrun clutch hub.
●
Apply petroleum jelly to needle bearing.
g.
Check that overrun clutch hub rotates as shown while holding
forward clutch hub.
SAT945A
SAT946A
SAT947A
SAT948A
SAT949A
AT-482
[RE4R01A]
ASSEMBLY
h.
Place transmission case into horizontal position.
i.
Install rear internal gear, forward clutch hub and overrun clutch
hub as a unit onto transmission case.
j.
Install needle bearing onto rear internal gear.
●
Apply petroleum jelly to needle bearing.
k.
Install bearing race onto rear of front internal gear.
●
Apply petroleum jelly to bearing race.
●
Securely engage pawls of bearing race with holes in front
internal gear.
l.
Install front internal gear on transmission case.
SAT527G
SAT951A
SAT952A
SAT953A
SAT954A
ASSEMBLY
AT-483
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
5.
Install output shaft and parking gear.
a.
Insert output shaft from rear of transmission case while slightly
lifting front internal gear.
●
Do not force output shaft against front of transmission
case.
b.
Carefully push output shaft against front of transmission case.
Install snap ring on front of output shaft.
●
Check to be sure output shaft cannot be removed in rear
direction.
c.
Install needle bearing on transmission case.
●
Pay attention to its direction — black side goes to rear.
●
Apply petroleum jelly to needle bearing.
d.
Install parking gear on transmission case.
e.
Install snap ring on rear of output shaft.
●
Check to be sure output shaft cannot be removed in for-
ward direction.
SAT216B
SAT957A
SAT217B
SAT218B
SAT960A
AT-484
[RE4R01A]
ASSEMBLY
6.
Install adapter case or rear extension.
a.
Install oil seal on adapter case or rear extension.
●
Apply ATF to oil seal.
b.
Install O-ring on revolution sensor.
●
Apply ATF to O-ring.
c.
Install revolution sensor on adapter case or rear extension.
d.
Install rear extension gasket on transmission case.
e.
Install parking rod on transmission case.
SAT157G
SAT147G
SAT963A
SAT964A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст