Nissan Frontier D22. Manual — part 419
DTC P0133, P0153 HO2S1
EC-779
[VG33E]
C
D
E
F
G
H
I
J
K
L
M
A
EC
7.
Make sure that “OK” is displayed after touching “SELF-DIAG
RESULTS”. If “NG” is displayed, refer to
Overall Function Check
UBS00DHZ
Use this procedure to check the overall function of the heated oxygen sensor 1 circuit. During this check, a
DTC might not be confirmed.
WITH GST
1.
Start engine and warm it up to normal operating temperature.
2.
Set voltmeter probes between ECM terminal 50 [HOS1 (B1) sig-
nal] or 51 [HOS1 (B2) signal] and engine ground.
3.
Check the following with engine speed held at 2,000 rpm con-
stant under no load.
–
The voltage fluctuates between 0 to 0.3V and 0.6 to 1.0V more
than 5 times within 10 seconds.
4.
If NG, go to
EC-783, "Diagnostic Procedure"
SEF658Y
1 time: 0 - 0.3V
→ 0.6 - 1.0V → 0 - 0.3V
2 times: 0 - 0.3V
→ 0.6 - 1.0V → 0 - 0.3V → 0.6 - 1.0V →
0 - 0.3V
SEF919UA
EC-780
[VG33E]
DTC P0133, P0153 HO2S1
Wiring Diagram
UBS00DI0
BANK 1
BBWA1075E
DTC P0133, P0153 HO2S1
EC-781
[VG33E]
C
D
E
F
G
H
I
J
K
L
M
A
EC
Specification data are reference values and are measured between each terminal and ground.
CAUTION:
Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in dam-
age to the ECM's transistor. Use a ground other than the ECM terminals, such as the ground.
: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.
TER-
MINAL
NO.
WIRE
COLOR
ITEM
CONDITION
DATA (DC Voltage)
50
B
Heated oxygen sensor
1 (bank 1)
[Engine is running]
●
Warm-up condition
●
Engine speed is 2,000 rpm
0 - Approximately 1.0V
SEF002V
EC-782
[VG33E]
DTC P0133, P0153 HO2S1
BANK 2
BBWA1076E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст