Nissan Frontier D22. Manual — part 156
VEHICLE SECURITY (THEFT WARNING) SYSTEM
BL-61
C
D
E
F
G
H
J
K
L
M
A
B
BL
2.
CHECK VEHICLE SECURITY LAMP RELAY CIRCUIT
1.
Check voltage between vehicle security lamp relay harness connector E22 terminal 3 (R/G) and 5 (Y/B).
2.
Check voltage between vehicle security lamp relay harness connector E22 terminal 6 (R/W) and 7 (Y/G).
OK or NG
OK
>> GO TO 3
NG
>> Check the following
●
Harness for open or short between vehicle security lamp relay and headlamps
●
Harness for open or short between vehicle security lamp relay and fuse
3.
CHECK VEHICLE SECURITY LAMP RELAY
Check vehicle security lamp relay.
Refer to
BL-63, "Vehicle Security Lamp Relay"
OK or NG
OK
>> Replace smart entrance control unit.
NG
>> Replace vehicle security lamp relay.
Battery voltage should
exist.
Battery voltage should
exist.
LEL068A
BL-62
VEHICLE SECURITY (THEFT WARNING) SYSTEM
STARTER INTERRUPT SYSTEM CHECK
1.
CHECK STARTER MOTOR INTERRUPT SIGNAL
1.
Turn ignition switch ON.
2.
Check voltage between smart entrance control unit connector M111 terminal 40 (R/W) and ground.
Refer to
BL-49, "Wiring Diagram — VEHSEC —"
.
OK or NG
OK
>> GO TO 2
NG
>> Check the following.
●
10A fuse [No. 5, located in fuse block (J/B)]
●
Harness for open or short between vehicle security relay and fuse
●
Harness for open or short between smart entrance control unit and vehicle security relay
2.
CHECK VEHICLE SECURITY RELAY
Check vehicle security relay.
Refer to
BL-63, "Vehicle Security Relay"
OK or NG
OK
>> Check system again.
NG
>> Replace relay.
LEL057A
VEHICLE SECURITY (THEFT WARNING) SYSTEM
BL-63
C
D
E
F
G
H
J
K
L
M
A
B
BL
ELECTRICAL COMPONENTS INSPECTION
Horn Relay
Check continuity between terminals 3 and 5.
Vehicle Security Relay
Check continuity between terminals 3 and 5.
Vehicle Security Lamp Relay
Check continuity between terminals 3 and 5, and terminals 6 and 7.
Conditions
Continuity
12V direct current supply between terminals 1 and 2
Yes
No current supply
No
WIIA0119E
Conditions
Continuity
12V direct current supply between terminals 1 and 2
Yes
No current supply
No
LEL827A
Conditions
Continuity
12V direct current supply between terminals 1 and 2
Yes
No current supply
No
BL-64
BODY (ALIGNMENT)
BODY (ALIGNMENT)
PFP:74312
Alignment
EIS002CM
●
All dimensions indicated in the figures are actual.
●
When using a tracking gauge, adjust both pointers to equal length, then check pointers and the gauge to
make sure there is no free play.
●
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
●
Measurements should be taken at the center of the mounting holes.
●
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
●
The coordinates of the measurement points are the distances measured from the standard line of “X”, “Y”
and “Z”.
WIIA0121E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст