Nissan Frontier D22. Manual — part 712
EX-1
EXHAUST SYSTEM
B ENGINE
CONTENTS
C
D
E
F
G
H
I
J
K
L
M
SECTION
A
EX
PREPARATION . . . . . . . . . . . . . . ... 2
Special Service Tool . . . . . . . . . . . . . 2
Commercial Service Tool . . . . . . . . . . . 2
EX-2
PREPARATION
PREPARATION
PFP:00002
Special Service Tool
EBS00HZJ
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tool
EBS00HZK
Tool number
(Kent-Moore No.)
Tool name
Description
KV10114400
(J38365)
Heated oxygen sensor wrench
Loosening or tightening rear heated oxygen
sensor.
a: 22 mm (0.87 in)
NT636
Tool name
(Kent-Moore No.)
Description
Oxygen sensor thread cleaner
(J-43897-18)
(J-43897-12)
Reconditioning the exhaust system threads
before installing a new oxygen sensor. Use
with anti-seize lubricant shown in Commercial
Service Tools.
a: J-43897-18 18 mm diameter, for Zirconia
Oxygen Sensor
b: J-43897-12 12 mm diameter, for Titania
Oxygen Sensor
Anti-seize lubricant
(Permatex™ 133AR or equivalent
meeting MIL specification MIL-A-907)
Lubricating oxygen sensor thread cleaning
tool when reconditioning exhaust system
threads.
AEM488
AEM489
EXHAUST SYSTEM
EX-3
C
D
E
F
G
H
I
J
K
L
M
A
EX
EXHAUST SYSTEM
PFP:20100
Removal and Installation
EBS00HZL
CAUTION:
●
Always replace exhaust gaskets with new ones when reassembling.
●
With the engine running, check all of the tube connections for exhaust gas leaks, and the entire
system for unusual noises.
●
Check to ensure that mounting brackets and mounting insulators are installed properly and free
from undue stress. Improper installation could result in excessive noise or vibration.
●
Discard any heated oxygen sensor which has been dropped from a height of more than 0.5 m (19.7
in) onto a hard surface such as a concrete floor; install a new one.
●
Before installing a new oxygen sensor, clean the exhaust tube threads using Oxygen Sensor
Thread Cleaner tool J-43897-18 or J-43897-12 and approved anti-seize lubricant.
●
Do not over-torque the oxygen sensor. Doing so may damage the oxygen sensor, resulting in the
MIL coming on.
EX-4
EXHAUST SYSTEM
KA24DE Models
WBIA0433E
1.
Three way convertor (under floor)
2.
Gasket
3.
Heated oxygen sensor 2 (rear)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст