Nissan Frontier D22. Manual — part 34
REVERSE CLUTCH
AT-105
[RL4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
REVERSE CLUTCH PISTON
●
Shake piston to assure that balls are not seized.
●
Apply compressed air to check ball oil hole opposite the return
spring to assure that there is no air leakage.
●
Also apply compressed air to oil hole on return spring side to
assure that air leaks past ball.
Assembly
ECS007K3
1.
Install D-ring and oil seal on piston.
●
Apply ATF to both parts.
●
Take care with the direction of oil seal.
2.
Install piston assembly by turning it slowly and evenly.
●
Apply ATF to inner surface of drum.
3.
Install return springs and spring retainer.
SAT846A
SAT847A
SAT848A
SAT849A
AT-106
[RL4R01A]
REVERSE CLUTCH
4.
Set Tool on spring retainer and install snap ring while compress-
ing clutch springs.
●
Do not align snap ring gap with spring retainer stopper.
5.
Install drive plates, driven plates, retaining plate and dish plate.
6.
Install snap ring.
7.
Measure clearance between retaining plate and snap ring. If not
within allowable limit, select proper retaining plate.
SAT620G
SAT850A
SAT842A
Specified clearance
Standard
: 0.5 - 0.8 mm (0.020 -
0.031 in)
Allowable limit
: 1.2 mm (0.047 in)
Retaining plate
: Refer to
.
SAT852A
REVERSE CLUTCH
AT-107
[RL4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
8.
Check operation of reverse clutch.
Refer to
.
SAT841A
AT-108
[RL4R01A]
HIGH CLUTCH
HIGH CLUTCH
PFP:31410
Components
ECS007K4
Disassembly and Assembly
ECS007K5
Service procedures for high clutch are essentially the same as those
for reverse clutch, with the following exceptions:
●
Check of high clutch operation
●
Removal and installation of return spring
LCIA0284E
SAT854A
SAT621G
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст