Nissan Frontier D22. Manual — part 208
RADIATOR
CO-15
[KA24DE]
C
D
E
F
G
H
I
J
K
L
M
A
CO
Inspection
EBS00GVI
1.
Apply pressure with Tool.
2.
Check radiator for leaks in water tank by looking for bubbles.
Specified pressure value
: 157 kPa (1.6 kg/cm
2
, 23
psi)
SLC933-A
SLC934
CO-16
[KA24DE]
COOLING FAN (CRANKSHAFT DRIVEN)
COOLING FAN (CRANKSHAFT DRIVEN)
PFP:21060
Removal and Installation
EBS00GVJ
●
Do not release the drive belt tension by removing the fan/water
pump pulley.
●
Fan coupling cannot be disassembled and should be replaced
as a unit. If front mark F is present, install fan so that side
marked F faces the front.
●
Install the drive belt only after the fan and fan coupling to water
pump flange bolts/nuts have been properly tightened.
●
Proper alignment of these components is essential. Improper
alignment will cause them to wobble and may eventually cause
the fan to separate from the water pump, causing extensive
damage.
Inspection
EBS00GVK
WARNING:
When the engine is running, keep hands and clothing away from moving parts such as drive belts and
fan.
●
Check fan coupling for rough operation, wobbling, oil leakage or
bent bimetal fins.
●
After assembly, verify the fan does not wobble or flap while the
engine is running.
ALC089
SLC072
SLC151B
SERVICE DATA AND SPECIFICATIONS (SDS)
CO-17
[KA24DE]
C
D
E
F
G
H
I
J
K
L
M
A
CO
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Thermostat
EBS00GVL
Radiator
EBS00GVM
Unit: kPa (kg/cm
2
, psi)
Valve opening temperature
76.5
°C (170°F)
Valve lift
More than 8 mm/90
°C (0.31 in/194°F)
Cap relief pressure
Standard
78 - 98 (0.8 - 1.0, 11 - 14)
Limit
59 (0.6, 9)
Leakage test pressure
157 (1.6, 23)
CO-18
[VG33E and VG33ER]
PRECAUTIONS
PRECAUTIONS
PFP:00001
Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”
EBS00GVN
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system may include seat belt switch inputs and dual stage front air bag modules. If
equipped with dual stage front air bag modules, the SRS system uses the seat belt switches to determine the
front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and
whether the front occupants are belted or unbelted. Information necessary to service the system safely is
included in the SRS and SB section of this Service Manual.
The vehicle may be equipped with a passenger air bag deactivation switch. Because no rear seat exists where
a rear-facing child restraint can be placed, the switch is designed to turn off the passenger air bag so that a
rear-facing child restraint can be used in the front passenger seat. The switch is located in the center of the
instrument panel, near the ashtray. When the switch is turned to the ON position, the passenger air bag is
enabled and could inflate for certain types of collision. When the switch is turned to the OFF position, the pas-
senger air bag is disabled and will not inflate. A passenger air bag OFF indicator on the instrument panel lights
up when the passenger air bag is switched OFF. The driver air bag always remains enabled and is not affected
by the passenger air bag deactivation switch.
WARNING:
●
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
●
Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
●
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
●
The vehicle may be equipped with a passenger air bag deactivation switch which can be operated
by the customer. When the passenger air bag is switched OFF, the passenger air bag is disabled
and will not inflate. When the passenger air bag is switched ON, the passenger air bag is enabled
and could inflate for certain types of collision. After SRS maintenance or repair, make sure the
passenger air bag deactivation switch is in the same position (ON or OFF) as when the vehicle
arrived for service.
Precautions for Liquid Gasket
EBS00GVO
REMOVAL OF LIQUID GASKET
●
After removing the mounting bolts and nuts, separate the mating
surface using a seal cutter and remove the sealant.
CAUTION:
Be careful not to damage the mating surfaces.
●
In areas where the cutter is difficult to use, use a plastic hammer
to lightly tap the areas where the sealant is applied.
CAUTION:
If for some unavoidable reason a tool such as a flat-bladed
screwdriver is used, be careful not to damage the mating sur-
faces.
PBIC0002E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст