Nissan Frontier D22. Manual — part 913
SRS-18
TROUBLE DIAGNOSIS
LHWA0002E
TROUBLE DIAGNOSIS
SRS-19
C
D
E
F
G
I
J
K
L
M
A
B
SRS
WHWA0027E
SRS-20
TROUBLE DIAGNOSIS
Passenger Air Bag Deactivation Switch Indicator Operation Check
EHS000SZ
1.
INDICATOR OPERATION CHECK
Check passenger air bag deactivation switch indicator operation
when turning ignition switch ON with passenger air bag deactivation
switch in ON and OFF positions.
OK or NG
OK
>> Passenger air bag deactivation switch indicator opera-
tion is OK. Conduct “SRS Operation Check”. Refer to
NG
>> GO TO 2.
2.
PERFORM SELF-DIAGNOSIS
Perform self-diagnosis using “AIR BAG” warning lamp in User mode. Refer to
NOTE:
The passenger air bag deactivation switch indicator can only be self-diagnosed when a malfunction
occurs and indicator illumination does not correspond to switch position.
OK or NG
OK
>> Replace passenger air bag deactivation switch including the key cylinder. Conduct “Passenger Air
Bag Deactivation Switch Indicator Operation Check” as a final check.
NG
>> Perform self-diagnosis using CONSULT-II or “AIR BAG” warning lamp in Diagnosis mode. Refer
to
SRS-31, "DIAGNOSTIC PROCEDURE 6"
respectively. If
the passenger air bag deactivation switch indicator remains illuminated with the passenger air bag
deactivation switch ON, leave passenger air bag deactivation switch in ON position during diagno-
sis. If the passenger air bag deactivation switch indicator does not illuminate with the passenger
air bag deactivation switch OFF, leave the passenger air bag deactivation switch in the OFF posi-
tion during diagnosis.
SRS Operation Check
EHS000T0
DIAGNOSTIC PROCEDURE 1
Checking Air Bag Operation by Using “AIR BAG” Warning Lamp — User Mode
1.
After turning ignition switch from “OFF” to “ON”, “AIR BAG”
warning lamp operates.
2.
Compare “AIR BAG” warning lamp operation to the chart below.
Passenger air bag deactivation switch
position
Passenger air bag deactivation switch
indicator
ON
Turns off within 7 seconds
OFF
Remains illuminated
WRS260
SRS800
TROUBLE DIAGNOSIS
SRS-21
C
D
E
F
G
I
J
K
L
M
A
B
SRS
Trouble Diagnoses with CONSULT-II
EHS000T1
DIAGNOSTIC PROCEDURE 2
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected
in self-diagnosis depending on control unit which carry out CAN communication.
1.
Turn ignition switch OFF.
2.
Connect CONSULT-II to the data link connector.
3.
Turn ignition switch ON.
4.
Touch “START (NISSAN BASED VHCL)”.
“AIR BAG” warning lamp operation — User mode —
SRS condition
Reference item
No malfunction is
detected. No further action
is necessary.
—
The system is malfunc-
tioning and needs to be
repaired as indicated.
, or
Air bag is deployed.
Seat belt pre-tensioner is
deployed.
Air bag fuse, diagnosis
sensor unit or harness is
malfunctioning and needs
to be repaired.
.
One of the following has
occurred and needs to be
repaired.
●
Meter fuse is blown.
●
“AIR BAG” warning
lamp circuit has open or
short.
●
Diagnosis sensor unit is
malfunctioning.
.
MRS095A
WKIA1606E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст