Nissan Frontier D22. Manual — part 801
MT-10
[FS5W71C]
TRANSMISSION ASSEMBLY
TRANSMISSION ASSEMBLY
PFP:32010
Removal and Installation
ECS007HF
REMOVAL
CAUTION:
Before separating the transmission from the engine, remove the crankshaft position sensor (OBD)
from the transmission. Be careful not to damage sensor edge or ring gear teeth.
WMT030
TRANSMISSION ASSEMBLY
MT-11
[FS5W71C]
D
E
F
G
H
I
J
K
L
M
A
B
MT
NOTE:
To prevent oil spills, drain transmission oil before removing transmission or insert plug into rear oil
seal after removing propeller shaft.
●
Be careful not to damage spline, sleeve yoke, and rear oil seal when removing propeller shaft.
1.
Remove battery negative terminal.
2.
Remove the crankshaft position sensor (OBD) from transmission upper side.
3.
Remove the clutch operating cylinder from transmission. Refer to
4.
Disconnect the vehicle speed sensor, back-up switch, and park/neutral position (PNP) switch harness
connectors.
5.
Remove the starter motor. Refer to
.
6.
Disconnect the exhaust hanger. Refer to
EX-3, "Removal and Installation"
.
7.
Remove the propeller shaft. Refer to
PR-8, "Removal and Installation"
.
8.
Remove the shift lever.
9.
Support the engine by placing a jack under the oil pan.
●
Do not place jack under oil pan drain plug.
10. Remove the transmission crossmember.
11. Separate the transmission from the engine.
WARNING:
Support manual transmission while removing it.
INSTALLATION
1.
Tighten transmission bolts.
*: With nut
2.
Installation is in the reverse order of removal.
SMT099A
Bolt No.
Tightening torque N·m (kg-m, ft-lb)
mm (in)
1
40 - 49 (4.0 - 5.0, 29 - 36)
65 (2.56)
2
40 - 49 (4.0 - 5.0, 29 - 36)
58 (2.28)
3*
16 - 21 (1.6 - 2.2, 12 - 15)
25 (0.98)
4
16 - 21 (1.6 - 2.2, 12 - 15)
16 (0.63)
AMT190
MT-12
[FS5W71C]
TRANSMISSION ASSEMBLY
Overhaul
ECS007HG
CASE COMPONENTS
WCIA0177E
TRANSMISSION ASSEMBLY
MT-13
[FS5W71C]
D
E
F
G
H
I
J
K
L
M
A
B
MT
1.
Park/neutral position (PNP) switch
2.
Clip
3.
Dust cover
4.
Oil Seal
5.
Reverse check sleeve bolt
6.
O-ring
7.
Vehicle speed sensor
8.
Rear extension bolts
9.
Rear extension
10. Bearing retainer
11.
Bearing
12. Adapter plate
13. Filler plug
14. Drain plug
15. Gasket
16. Front cover
17. Ball pin
18. Washer
19. Front cover bolt
20. Transmission case
21. Air breather
22. Back-up lamp switch
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст