Nissan Rogue. Manual — part 377
DLK-350
>
[WITHOUT INTELLIGENT KEY SYSTEM]
THIS PAGE INTENTIONALLY LEFT BLANK
LKIA2029GB
2015 Rogue NAM
THIS PAGE INTENTIONALLY LEFT BLANK
DLK-351
>
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
2015 Rogue NAM
DLK-352
< SYMPTOM DIAGNOSIS >
[WITHOUT INTELLIGENT KEY SYSTEM]
POWER DOOR LOCK SYSTEM SYMPTOMS
SYMPTOM DIAGNOSIS
POWER DOOR LOCK SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000011279130
DOOR LOCK/UNLOCK FUNCTION MALFUNCTION
NOTE:
• Before performing the diagnosis in the following table, check “WORK FLOW”. Refer to
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and
check each symptom.
• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column
in this order.
Symptom
Diagnosis/service procedure
Reference page
Key reminder door function does not operate
properly.
1.
Check door switch.
2.
Check key switch.
3.
Check Intermittent Incident.
Power door lock does not operate with main
power window and door lock/unlock switch or
power window and door lock/unlock switch
RH.
1.
Check BCM Power supply and ground circuit.
2.
Check main power window and door lock and unlock switch.
3.
Check power window and door lock and unlock switch RH.
4.
Check Intermittent Incident.
Specific door lock actuator does not operate.
1.
Check door lock actuator.
Driver side
Passenger side
Rear LH
Rear RH
2.
Check Intermittent Incident.
Power door locks do not operate with front
door lock key cylinder switch LH.
1.
Check key cylinder switch.
2.
Replace BCM.
Vehicle speed sensing auto door LOCK oper-
ation does not operate.
1.
Ensure automatic door lock/unlock function (lock operation)
is enabled.
2.
Check combination meter vehicle speed signal.
3.
Check intermittent incident.
Ignition OFF interlock auto door UNLOCK
function does not operate.
1.
Ensure automatic door lock/unlock function (unlock opera-
tion) is enabled.
2.
Check BCM for DTCs.
3.
Check intermittent incident.
2015 Rogue NAM
REMOTE KEYLESS ENTRY SYSTEM SYMPTOMS
DLK-353
< SYMPTOM DIAGNOSIS >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REMOTE KEYLESS ENTRY SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000011279131
REMOTE KEYLESS ENTRY SYSTEM
Symptom
Diagnoses/service procedure
Reference
page
All functions of remote keyless entry system do not
operate.
1. Keyfob battery and function check (use Remote Keyless Entry
Tester [– (J-43241)])
NOTE:
If the result of keyfob function check is OK, keyfob is not malfunc-
tioning.
The new ID of keyfob cannot be entered.
1. Keyfob battery and function check (use Remote Keyless Entry
Tester [– (J-43241)])
NOTE:
If the result of keyfob function check is OK, keyfob is not malfunc-
tioning.
2. Door switch check
3. Replace BCM.
Door lock or unlock does not function.
(If the power door lock system does not operate
manually, check power door lock system)
1. Keyfob battery and function check (use Remote Keyless Entry
Tester [– (J-43241)])
NOTE:
If the result of keyfob function check is OK, keyfob is not malfunc-
tioning.
2. Replace BCM.
Hazard and horn reminder does not activate properly
when pressing lock or unlock button of keyfob.
1. Check hazard and horn reminder mode with CONSULT
NOTE:
Hazard and horn reminder mode can be changed.
First check the hazard and horn reminder mode setting.
2. Door switch check
3. Replace BCM.
Hazard reminder does not activate properly when
pressing lock or unlock button of keyfob.
(Horn reminder OK)
1. Check hazard reminder mode with CONSULT
NOTE:
Hazard reminder mode can be changed.
First check the hazard reminder mode setting.
2. Check hazard function with hazard switch
—
3. Replace BCM.
Horn reminder does not activate properly when
pressing lock or unlock button of keyfob.
(Hazard reminder OK)
1. Check horn reminder mode with CONSULT
NOTE:
Horn reminder mode can be changed.
First check the horn reminder mode setting.
2. Check horn function with horn switch
—
3. IPDM E/R operation check
4. Replace BCM.
Room lamp illumination does not operate properly.
1. Room lamp operation check
2. Door switch check
3. Replace BCM.
Panic alarm (horn and headlamp) does not activate
when panic alarm button is continuously pressed.
1. Keyfob battery and function check (use Remote Keyless Entry
Tester [– (J-43241)])
NOTE:
If the result of keyfob function check is OK, keyfob is not malfunc-
tioning.
2. Replace BCM.
2015 Rogue NAM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст