Nissan Rogue. Manual — part 20
AV-72
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
USB INTERFACE AND AUX IN JACK
USB INTERFACE AND AUX IN JACK
Removal and Installation
INFOID:0000000011276769
REMOVAL
1. Remove cluster lid C. Refer to
IP-22, "Removal and Installation"
2. Release the pawls (A) on the back of USB interface and AUX in
jack (2), then remove from the front of cluster lid C (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1582ZZ
AV
MICROPHONE
AV-73
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
MICROPHONE
Removal and Installation
INFOID:0000000011276770
REMOVAL
1. Remove the map lamp assembly. Refer to
INL-55, "Removal and Installation"
.
2. Release harness connector (A) by sliding rearward to remove
from the pawl (B).
3. Release pawls (C) and remove the microphone (1) from the
front room/map lamp assembly.
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1583ZZ
AV-74
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
REAR VIEW CAMERA
REAR VIEW CAMERA
Removal and Installation
INFOID:0000000011276771
REMOVAL
1. Remove the back door outer finisher. Refer to
EXT-51, "Removal and Installation"
.
2. Release pawl, disconnect harness connector from rear view camera and remove.
INSTALLATION
Installation is in the reverse order of removal.
AV
ANTENNA BASE
AV-75
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ANTENNA BASE
Exploded View
INFOID:0000000011373313
Removal and Installation
INFOID:0000000011276772
REMOVAL
1. Remove the luggage side upper finisher (RH). Refer to
INT-36, "LUGGAGE SIDE UPPER FINISHER :
.
2. Partially lower headlining (rear). Refer to
INT-30, "Removal and Installation"
3. Disconnect harness connectors from antenna feeder.
4. Remove nut from antenna base and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
If the antenna base nut is not properly tightened, lower sensitivity of the antenna may be experienced.
If the nut is over tightened, this will deform the roof panel.
Disassembly and Assembly
INFOID:0000000011373315
DISASSEMBLY
Insert a suitable tool into gaps between antenna base (2) and the
cover (1), then remove the cover (1) from antenna base (2).
ASSEMBLY
Assembly is in the reverse order of disassembly.
AWNIA3705ZZ
1. Antenna rod
2. Antenna base
A. Antenna nut
ALNIA1335ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст