Nissan Rogue. Manual — part 622
FRONT FOG LAMP AIMING ADJUSTMENT
EXL-117
< PERIODIC MAINTENANCE >
[HALOGEN HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
FRONT FOG LAMP AIMING ADJUSTMENT
Aiming Adjustment Procedure
INFOID:0000000011280780
Aiming Chart
NOTE:
• (LH) Front fog lamp aiming specifications shown, (RH) similar.
• Check the following conditions before performing the aiming adjustment.
- Keep all tires inflated to correct pressure.
- Place vehicle on level ground.
- See that vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and
tools). Have the driver or equivalent weight placed in driver seat.
- When performing adjustment, if necessary, cover the headlamps and opposite front fog lamp.
1. Set the distance between the screen and the center of the front
fog lamp lens as shown.
(1) Aiming screen or a matte white surface
(2) 7.62 m (25 ft)
(3) Floor to center of front fog lamp lens
(4) Floor
2. Turn front fog lamps ON.
AWLIA2219ZZ
1.
Vertical center line of front fog
lamp (LH)
2.
Lamp center above ground
3.
Front fog lamp high intensity
area (LH)
4.
Vertical center line of front fog
lamp (RH)
5.
Vertical center axis
A.
100mm (4in)
AWLIA2318ZZ
EXL-118
< PERIODIC MAINTENANCE >
[HALOGEN HEADLAMP]
FRONT FOG LAMP AIMING ADJUSTMENT
3. Access adjusting screw (A) from underneath front bumper fas-
cia. Adjust front fog lamps using adjusting screw so that the top
edge of the high intensity zone is at the front fog lamp centers
above ground.
ALLIA0035ZZ
FRONT COMBINATION LAMP
EXL-119
< REMOVAL AND INSTALLATION >
[HALOGEN HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
REMOVAL AND INSTALLATION
FRONT COMBINATION LAMP
Exploded View
INFOID:0000000011280781
Removal and Installation
INFOID:0000000011280782
REMOVAL
1. Remove front bumper fascia. Refer to
EXT-17, "Removal and Installation"
.
2. Remove front combination lamp bolts and clip.
3. Pull front combination lamp forward.
4. Disconnect the harness connectors from the front combination lamp and remove.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
After installation, perform headlamp aiming adjustment. Refer to
Bulb Replacement
INFOID:0000000011280783
WARNING:
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
CAUTION:
• Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to pre-
vent damage to the bulb.
1.
Front fender
2.
Front combination lamp
Clip
ALLIA1401ZZ
EXL-120
< REMOVAL AND INSTALLATION >
[HALOGEN HEADLAMP]
FRONT COMBINATION LAMP
• Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect
the performance of lamp. When replacing bulb, be sure to replace it with new one.
HEADLAMP (LOW BEAM) BULB
Removal
1. Rotate the bulb counterclockwise and remove from the front combination lamp.
2. Disconnect the harness connector from bulb and remove.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
HEADLAMP (HIGH BEAM) BULB
Removal
1. Remove plastic cover.
2. Rotate the bulb counterclockwise and remove from the front combination lamp.
3. Disconnect the harness connector from bulb and remove.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
SIDE MARKER LAMP BULB
Removal
1. Rotate the bulb counterclockwise and remove from the front combination lamp.
2. Remove the bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
TURN SIGNAL LAMP BULB
Removal
1. Rotate bulb socket counterclockwise and remove from the front combination lamp.
2. Remove the bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст