Nissan Rogue. Manual — part 250
DAS
SIDE CAMERA
DAS-171
< REMOVAL AND INSTALLATION >
[DRIVER ASSISTANCE SYSTEM]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
SIDE CAMERA
Removal and Installation
INFOID:0000000011277336
REMOVAL
1. Remove door mirror rear finisher. Refer to
MIR-26, "Removal and Installation"
2. Remove screws (A) and side camera (1) from door mirror fin-
isher (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform camera image calibration (if equipped with around view camera). Refer to
.
AWOIA0094ZZ
DAS-172
< REMOVAL AND INSTALLATION >
[DRIVER ASSISTANCE SYSTEM]
BSW INDICATOR
BSW INDICATOR
Removal and Installation
INFOID:0000000011277337
REMOVAL
1. Remove the front door finisher. Refer to
INT-15, "Removal and Installation"
2. Release the door mirror corner finisher using a suitable tool. Refer to
3. Disconnect the harness connector (A), release the harness clip
and remove the door mirror corner finisher (1).
4. Remove screws and blind spot warning indicator (2).
INSTALLATION
Installation is in the reverse order of removal.
AWOIA0071ZZ
DAS
AROUND VIEW MONITOR CONTROL UNIT
DAS-173
< REMOVAL AND INSTALLATION >
[DRIVER ASSISTANCE SYSTEM]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
AROUND VIEW MONITOR CONTROL UNIT
Exploded View
INFOID:0000000011277338
Removal and Installation
INFOID:0000000011277339
REMOVAL
CAUTION:
Before replacing around view monitor control unit, save or print current vehicle specification with
CONSULT configuration before replacement. Refer to
1. Remove glove box assembly. Refer to
IP-24, "Removal and Installation"
2. Remove around view monitor control unit screws.
3. Disconnect the harness connector from the around view monitor control unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Replace the around view monitor control unit if it has been dropped or sustained an impact.
• When replacing around view monitor control unit, you must perform "After Replace ECU" with CON-
• Perform camera image calibration. Refer to
AWNIA3694ZZ
1.
Around view monitor control unit A. Harness connector
DAS-174
< REMOVAL AND INSTALLATION >
[DRIVER ASSISTANCE SYSTEM]
WARNING SYSTEMS SWITCH
WARNING SYSTEMS SWITCH
Exploded View
INFOID:0000000011485227
Removal and Installation
INFOID:0000000011277340
REMOVAL
1. Remove instrument lower panel LH. Refer to
IP-23, "Removal and Installation"
.
2. Remove screws and upper switch carrier, then remove screws and lower switch carrier.
3. Release pawls using suitable tool, then remove warning sys-
tems switch from the lower switch carrier.
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
1.
Upper switch carrier
2.
Lower switch carrier
3. blank
4.
Warning systems switch
5.
AWD lock switch
6. Hill decent control switch
7.
Instrument lower panel LH
8.
Automatic back door main switch
9. Automatic back door switch
10. Sport mode switch
11. VDC OFF switch
ALJIA1521ZZ
ALJIA1522ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст