Nissan Rogue. Manual — part 396
DLN-28
< WIRING DIAGRAM >
[TRANSFER: TY21C]
AWD SYSTEM
AADIA0802GB
AWD SYSTEM
DLN-29
< WIRING DIAGRAM >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
AADIA0803GB
DLN-30
< WIRING DIAGRAM >
[TRANSFER: TY21C]
AWD SYSTEM
AADIA0804GB
DIAGNOSIS AND REPAIR WORK FLOW
DLN-31
< BASIC INSPECTION >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000011278310
DETAILED FLOW
1.
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing
and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints
carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION:
Customers are not professional. Never guess easily like “maybe the customer means that...,” or
“maybe the customer mentions this symptom”.
>> GO TO 2.
2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer
obtained by interview. Also check that the symptom is not caused by protection function. Refer to
CAUTION:
When the symptom is caused by normal operation, fully inspect each portion and obtain the under-
standing of customer that the symptom is not caused by a malfunction.
>> GO TO 3.
3.
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
Perform “Self Diagnostic Result” of “ALL MODE AWD/4WD”.
Is any DTC detected?
YES
>> Record or print self diagnostic results. GO TO 4.
NO
>> GO TO 6.
4.
RECHECK SYMPTOM
With CONSULT
1. Erase “Self Diagnostic Result” of “ALL MODE AWD/4WD”.
2. Perform DTC confirmation procedures for the error detected system.
NOTE:
If some DTCs are detected at the same time, determine the order for performing the diagnosis based on
22, "DTC Inspection Priority Chart"
Is any DTC detected?
YES
>> GO TO 5.
NO
>> Check harness and connectors based on the information obtained by interview. Refer to
.
5.
REPAIR OR REPLACE ERROR-DETECTED PARTS
• Repair or replace error-detected parts.
• Reconnect part or connector after repairing or replacing.
• When DTC is detected, erase “Self Diagnostic Result” of “ALL MODE AWD/4WD”.
>> GO TO 7.
6.
IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSIS
Estimate error-detected system based on symptom diagnosis and perform inspection.
Can the error-detected system be identified?
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст