Nissan Qashqai J11. Manual — part 585
EX-20
< PRECAUTION >
[R9M]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Procedure without Cowl Top Cover
INFOID:0000000010502618
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc to prevent damage to
windshield.
Removal and Installation
INFOID:0000000010287091
CAUTION:
• Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat
resistance, corrosion resistance, and shape.
• Perform the operation with the exhaust system fully cooled down because the system will be hot
just after engine stops.
• Be careful not to cut your hand on the heat insulator edge.
PIIB3706J
EXHAUST SYSTEM
EX-21
< PERIODIC MAINTENANCE >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
PERIODIC MAINTENANCE
EXHAUST SYSTEM
Inspection
INFOID:0000000010287092
Check exhaust pipes, muffler and mounting for improper attachment,
leaks, cracks, damage or deterioration.
• If anything is found, repair or replace damaged parts.
SMA211A
EX-22
< REMOVAL AND INSTALLATION >
[R9M]
EXHAUST SYSTEM
REMOVAL AND INSTALLATION
EXHAUST SYSTEM
Exploded View
INFOID:0000000010287093
for symbols in the figure.
Removal and Installation
INFOID:0000000010287094
REMOVAL
1.
Remove main muffler.
2.
Disconnect exhaust valve.
3.
Unclip and move aside harness of exhaust throttle valve.
4.
Remove exhaust front tube.
INSTALLATION
Note the following, and install in the reverse order of removal.
Exhaust Front Tube and Main Muffler
1.
Gasket
2.
Mounting rubber
3.
Exhaust front tube
4.
Exhaust shutter
5.
Exhaust center tube
6.
Main muffler
E1BIA1126GB
EXHAUST SYSTEM
EX-23
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
1.
Perform "Exhaust throttle valve position learning". Refer to
or removing exhaust throttle valve. Refer to
EC9-143, "Special Repair Requirement List"
.
CAUTION:
• Always replace exhaust gaskets with new ones when reassembling.
• If the insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the insula-
tor, remove them.
• When installing the insulator avoid large gaps or interference between the insulator and each
exhaust pipe.
• Remove deposits from the sealing surface of each connection. Connect them securely to avoid gas
leakage.
• If it is difficult to install mounting rubber, use mild detergent for smooth installation.
• When installing each mounting rubber, avoid twisting or unusual extension in up/down and right/left
directions.
• Temporarily tighten mounting nuts. Check each part for unusual interference, and then tighten them
to the specified torque.
Inspection
INFOID:0000000010287095
INSPECTION AFTER INSTALLATION
• With the engine running, check exhaust tube joints for gas leakage and unusual noises.
• Check to ensure that mounting brackets and mounting insulators are installed properly and free from undue
stress. Improper installation could result in excessive noise and vibration.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст