Nissan Qashqai J11. Manual — part 533
EC9-288
< DTC/CIRCUIT DIAGNOSIS >
[R9M]
P1480 EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
YES
>> INSPECTION END
NO
>> Replace exhaust electric throttle control actuator.
Component Inspection (Exhaust Throttle Position Sensor)
INFOID:0000000010503305
1.
CHECK EXHAUST THROTTLE POSITION SENSOR
1.
Turn ignition switch ON.
2.
Check the voltage between ECM terminals as follows.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace exhaust electric throttle control actuator.
ECM
Voltage
+
-
Terminal
113
117
0.2 – 4.8 V
P1481 EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
EC9-289
< DTC/CIRCUIT DIAGNOSIS >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EC9
N
P
O
P1481 EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
DTC Logic
INFOID:0000000010309278
DTC DETECTION LOGIC
NOTE:
If DTC P1481 is displayed with DTC P0651, first perform the trouble diagnosis for DTC P0651. Refer to
.
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 1 minute before conducting the next test.
>> GO TO 2.
2.
PERFORM DTC CONFIRMATION PROCEDURE
1.
Start engine and wait at least 1 second.
2.
Check DTC.
Is DTC detected?
YES
>>
EC9-289, "Diagnosis Procedure"
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000010503309
1.
CHECK ECM HARNESS CONNECTOR CONNECTIONS
1.
Turn ignition switch OFF.
2.
Check ECM harness connector connection.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace error-detected parts.
2.
CHECK EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR HARNESS CONNECTOR CONNEC-
TIONS
Check exhaust electric throttle control actuator harness connector connection.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace error-detected parts.
3.
CHECK EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR POWER SUPPLY CIRCUIT
Check the power supply of the exhaust electric throttle control actuator.
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P1481
EXHAUST E/THROTTLE
CONT ACTUATOR
(Exhaust electric/throttle con-
trol actuator)
• 1.DEF: —
• 2.DEF: OPERATION TEM-
PERATURE TOO HIGH
• ECM detects the exhaust electric throttle control
valve command circuit is short to ground.
• ECM detects the exhaust electric throttle control
valve command circuit is short to power.
• ECM detects an over temperature of the exhaust
electric throttle control actuator.
• Harness and connectors
(Exhaust electric throttle con-
trol actuator command circuit is
open or shorted.)
• Exhaust electric throttle control
actuator
• Exhaust throttle valve stuck
EC9-290
< DTC/CIRCUIT DIAGNOSIS >
[R9M]
P1481 EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Perform trouble diagnosis for power supply circuit.
4.
CHECK EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR CIRCUIT FOR OPEN AND SHORT
1.
Turn ignition switch OFF.
2.
Check exhaust electric throttle control actuator circuit for open and short.
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Repair or replace error-detected parts.
5.
DTC CONFIRMATION PROCEDURES
1.
Erase DTC.
2.
Perform DTC confirmation procedure again. Refer to
.
Is the DTC P1481 displayed again?
YES
>> GO TO 6.
NO
>> Check intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
6.
CHECK EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
Perform
EC9-291, "Component Inspection (Exhaust Throttle Position Sensor)"
,
Inspection (Exhaust Throttle Control Motor)"
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
NO
>> Replace exhaust electric throttle control actuator.
Component Inspection (Exhaust Throttle Control Motor)
INFOID:0000000010503310
1.
CHECK EXHAUST THROTTLE CONTROL MOTOR
1.
Disconnect exhaust electric throttle control actuator harness connector.
2.
Check the resistance between exhaust throttle control motor terminals as follows.
Is the inspection result normal?
+
-
Voltage
Exhaust electric throttle control ac-
tuator
Connector
Terminal
F59
5
Ground
Battery voltage
+
+
Continuity
ECM
Exhaust electric throttle
control actuator
Connector
Terminal
Connector
Terminal
F83
104
F59
1
Existed
113
3
117
2
132
5
147
6
Exhaust throttle control actuator
Resistance
+
-
Terminal
5
6
2.65 - 3.25
Ω
P1481 EXHAUST ELECTRIC THROTTLE CONTROL ACTUATOR
EC9-291
< DTC/CIRCUIT DIAGNOSIS >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EC9
N
P
O
YES
>> INSPECTION END
NO
>> Replace exhaust electric throttle control actuator.
Component Inspection (Exhaust Throttle Position Sensor)
INFOID:0000000010503311
1.
CHECK EXHAUST THROTTLE POSITION SENSOR
1.
Turn ignition switch ON.
2.
Check the voltage between ECM terminals as follows.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace exhaust electric throttle control actuator.
ECM
Voltage
+
-
Terminal
113
117
0.2 – 4.8 V
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст