Nissan Qashqai J11. Manual — part 115
GLOW PLUG
EM-399
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
GLOW PLUG
Exploded View
INFOID:0000000010281991
Removal and Installation
INFOID:0000000010281992
REMOVAL
CAUTION:
Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken.
1.
Disconnect the battery cable from the negative terminal.
2.
Remove air inlet hose 1. Refer to
3.
Remove damper valve from intake manifold. Refer to
4.
Remove swirl valve from intake manifold. Refer to
5.
Disconnect harness connector from glow plug.
6.
Remove glow plug.
CAUTION:
• When removing or installing, never use such tools as an air impact wrench.
• Handle it carefully without giving any impact, even after removal.
INSTALLATION
1.
Remove adhered carbon from glow plug installation hole with a reamer.
2.
Install glow plug.
3.
Install in the reverse order of removal, for the rest of parts.
1.
Glow plug
Refer to
E1BIA1207GB
EM-400
< REMOVAL AND INSTALLATION >
[R9M]
VACUUM PUMP
VACUUM PUMP
Exploded View
INFOID:0000000010281993
Removal and Installation
INFOID:0000000010281994
REMOVAL
1.
Remove battery. Refer to
PG-155, "Removal and Installation"
.
2.
Disconnect vacuum hoses.
3.
Remove vacuum pump.
• Loosen mounting bolts in reverse order as shown in the figure.
INSTALLATION
Note the following, and install in the reverse order of removal.
Vacuum pump
1.
Vacuum pump
2.
Gasket
3.
Vacuum hose
A.
To brake booster
B.
To turbocharger boost control sole-
noid valve
C.
To coolant outlet unit regulation sole-
noid valve
Refer to
for symbols in the figure.
E1BIA1208GB
E1BIA0614ZZ
VACUUM PUMP
EM-401
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
• Tighten mounting bolts in numerical order as shown in the figure.
CAUTION:
Be sure to check that the vacuum pump is in contact with the
cylinder head before tightening the mounting bolts.
E1BIA0614ZZ
EM-402
< REMOVAL AND INSTALLATION >
[R9M]
OIL SEPARATOR
OIL SEPARATOR
Exploded View
INFOID:0000000010281995
Removal and Installation
INFOID:0000000010281996
REMOVAL
1.
Remove fuel injection cover.
2.
Remove PCV hose.
3.
Disconnect harness connector of fuel injector.
4.
Loosen oil separator insulator mounting bolts.
5.
Remove oil separator.
1.
Oil separator
2.
Oil filler plug
3.
PCV hose
4.
Gasket
5.
Cylinder head
A.
Refer to
B.
To turbocharger air inlet pipe
Refer to
for symbols in the figure.
E1BIA1209GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст