Nissan Qashqai J11. Manual — part 375
ECK-60
< SYSTEM DESCRIPTION >
[K9K]
DIAGNOSIS SYSTEM (ECM)
DMPR VLV SEN VO
mV
Inlet throttle position sensor voltage
EST INL FLP TMP
°
C or
°
F
Inlet throttle upstream temperature
INL FLP SEN SUP VO
mV
Inlet throttle position sensor signal voltage is displayed.
EGR POSITION
%
High pressure EGR position is displayed.
TURB TMP SET
°
C or
°
F
Exhaust gas temperature set point is displayed.
MANIFOLD PRESSURE
mbar
Intake manifold pressure computed from the TC boost sen-
sor is displayed.
EXH GAS TEMP (UPSTM CAT)
°
C or
°
F
This item is indicated, but not used.
EXH THRTL VALVE OFFSET
%
Exhaust Air Flap - Current value of the “'last closed thrust
position” learnt.
OIL DILUTION INFORMATION
%
Oil dilution rate
L/ PRES EGR/V FIRST OFFSET
%
Low Pressure EGR valve - Current value of the first closed
thrust position learnt
L/PRES EGR VALVE POSITION
%
Low pressure EGR volume control valve position is dis-
played.
EXH THROTTLE POSITION
%
Exhaust throttle opening rate is displayed.
ALTERNATOR POWER
W
Alternator power
L/PRES EGR VALVE POS SEN
mV
Low pressure EGR volume control valve position sensor
signal voltage is displayed.
ENGINE REV COUNT
—
Number of engine revolutions since the last oil drain
ENG OIL DILU RATIO
%
Current oil dilution rate for oil wear estimation
ENG TORQUE
Nm
Engine output torque calculated by ECM is displayed.
EXH THROTTLE POS SEN
mV
Exhaust throttle position sensor signal voltage is displayed.
DPF PRESSURE
hPa
Memorized difference pressure to apply on the CSF differ-
ential pressure for adaptation
Cruise control setting
km or mile
The preset ASCD vehicle speed is displayed.
DURATION OF RESUME BUT-
TON PRESS
s
Duration of resume button press is displayed.
DURATION OF + BUTTON
PRESS
s
Duration of SET/+ button press is displayed.
DURATION OF - BUTTON
PRESS
s
Duration of SET/- button press is displayed.
DURATION OF SUSPEND BUT-
TON PRESS
s
Duration of suspend button press is displayed.
NUMBER OF ABNORMAL CC/
SL TRANSITIONS
—
Maximum value of blocked button detection counter
MOTOR
RUNNING/
OFF/
STALLED/
CRANKING
Engine status is displayed.
1ST IN VAL OPEN PR
YES/NO
Inlet throttle valve offset - first opened learning running
1ST IN VAL CLOS PR
YES/NO
Inlet throttle valve offset - first closed learning running
THERMOPLUNGER
DETCT/AC-
TIVE
Thermoplunger No.1 status is displayed.
THERMOPLNGR 2
DETCT/AC-
TIVE
Thermoplunger No.2 status is displayed.
THERMOPLNGR 3
DETCT/AC-
TIVE
Thermoplunger No.3 status is displayed.
EGR FUN PROG
YES/NO
High pressure EGR volume control valve offset - first learn-
ing running
Monitor item
Unit
Description
Remarks
DIAGNOSIS SYSTEM (ECM)
ECK-61
< SYSTEM DESCRIPTION >
[K9K]
C
D
E
F
G
H
I
J
K
L
M
A
ECK
N
P
O
CAM TDC SYNC
NOT DONE/
DONE
Camshaft/crankshaft synchronization status is displayed.
C/U+AFTR IGN
MISSING/
PRESENT
Ignition switch status is displayed.
CLUTCH PEDAL SWITCH
INACTIVE/AC-
TIVE/
BLOCKED
Clutch pedal position switch status is displayed.
CCS LMT BTN
INACTIVE/IN-
VALID/CO.1/
SUSPD/MI-
NUS/PLUS/
RSTRT
ASCD steering switch status is displayed.
• INACTIVE: unpressed
• INVALID: invalid voltage
• CO.1: open circuit
• SUSPD: suspend switch pressed
• MINUS: SET/
−
switch pressed
• PLUS: SET/+ switch pressed
• RSTRT: RES switch pressed
CRS CN/SPD LMT OP
OFF/SL ON/SL
SUS/SL INHI/
CC ON/CC
SUS/CC INHI/
NONE
ASCD and speed limiter status is displayed.
• OFF: ASCD and speed limiter is no activated.
• SL ON: speed limiter is activated. (active or over speed)
• SL SUS: speed limiter is activated. (awaiting or sus-
pended)
• SL INHI: speed limiter requested and in failure
• CC ON: ASCD is activated. (active)
• CC SUS: ASCD is activated. (awaiting or suspended)
• /CC INH: ASCD requested and in failure
• NONE: ASCD and speed limiter not present
CC/SL CONNECTION AFTER
CC BUTTON PRESSED
Not detected/
DETCT
When ASCD MAIN switch is pressed, it displays actual
ASCD operating condition detected by ECM.
CC/SL CONNECTION AFTER
SL BUTTON PRESSED
Not detected/
DETCT
When speed limiter MAIN switch is pressed, it displays ac-
tual speed limiter operating condition detected by ECM.
CRS C/SPD LIM
Inactive/REG-
UL/LIMIT/Inco-
herence
Speed limiter MAIN switch status is displayed.
CC/SL ACT DR
STAT1/STAT2/
STAT3/STAT4/
STAT5
Cancellation condition of ASCD/speed limiter is displayed.
• STAT1: ASCD/speed limiter main switch changed.
• STAT2: Suspend button is pressed.
• STAT3: ASCD brake switch is ON.
• STAT4: Clutch pedal position switch is ON.
• STAT5: Shift the selector lever to “N” position.
• NONE: Deactivation
TRC/ANTI-YAW CNT
No/Yes
Anti skid regulation or anti yaw control in regulation.
CRUISE CONTROL
COR/Incoher-
ence
Speed/set point ratio too small.
PARKING BRAKE
RELES/AP-
PLIED
Parking brake status is displayed.
CC CONT INHI INJ
No/Yes
ASCD system engine control inhibition
SL INHI INJECTION
No/Yes
Speed limiter system engine control inhibition
CLUTCH INFO UNAV
Not detected/
DETCT
Clutch information unavailable is detected.
BRAKE INFO UNAVAI
Not detected/
DETCT
Brake information unavailable is detected.
BRAKE INFO ABSENT
Not detected/
DETCT
Brake information absent is detected.
DECELE W/O BRAKE
Not detected/
DETCT
Sudden braking detected without brake information
SHA DEC W/O BRAK
Not detected/
DETCT
Braking detected without brake information
Monitor item
Unit
Description
Remarks
ECK-62
< SYSTEM DESCRIPTION >
[K9K]
DIAGNOSIS SYSTEM (ECM)
CC INHI INJECTION
Not detected/
DETCT
ASCD inhibition is detected.
DISP VEHI SP UNAV
Not detected/
DETCT
Displayed vehicle speed unavailable is detected.
ACT SP INFO ABSE
Not detected/
DETCT
Real vehicle speed unavailable is detected.
DISP SP INFO ABSE
Not detected/
DETCT
Display vehicle speed absence is detected.
CHANGE SP UNIT
Not detected/
DETCT
Change of the displayed speed unit is detected.
SL INHI INJECTION
Not detected/
DETCT
Speed limiter inhibition is detected.
VEHICLE SPEED UNIT
km/h/mph
Vehicle speed is displayed.
WIRED BRAK CONTA
OFF/
PRESSED/
INTM
ASCD brake switch state is displayed.
CC OPERATING RELIABLY
STAT1/STAT2/
STAT3
State of the failures which cause irreversible ASCD safety
failure is displayed.
• STAT1: Presence of ASCD force request despite the
ASCD deactivation
• STAT2: Activation of the open brake switch without
ASCD deactivation
• STAT3: Activation of the minimum travel clutch switch
without ASCD deactivation
TURBO REGULATION
Inactive/REG-
UL/INTM/DIAG
MODE/
PRTCT/MAX
Boost regulation state is displayed.
CC/SL CONN AUTH
Inactive/AC-
TIVE
Authorization to connect ASCD and speed limiter options
status is displayed.
LOW FUEL LEVEL INFORMA-
TION
OK/Low
LOW FUEL LEVEL INFORMATION is displayed.
WTR DIESEL DETECTR
Not detected/
DETCT
This item is not used.
COOLING FAN ACTIV REQ
INACTIVE/AC-
TIVE
Cooling fan request status is displayed.
CC/SL SPEED SIGNAL MONI-
TORING
STAT1/STAT2/
STAT3/STAT4/
STAT5/STAT6
State of the reversible failures not due to ASCD/speed lim-
iter which cause ASCD/speed limiter failure
• STAT1: Real vehicle speed unavailable is detected.
• STAT2: Displayed vehicle speed unavailable is detected.
• STAT3: Real vehicle speed absence is detected.
• STAT4: Display vehicle speed absence is detected.
• STAT5: Change of the displayed speed unit is detected.
• STAT6: Speed limiter inhibition is detected.
COMBU MODE SET
NORMAL/
1.DEF/2.DEF/
3.DEF/STAT4/
RESERV/
STAT5/STAT6/
4.DEF
REQUIREMENT VALUE OF COMBUSTION MODE isdis-
played.
COMBUSTION MODE
NORMAL/
2.DEF/3.DEF/
STAT4/RE-
SERVED/
1.DEF/STAT5/
STAT6/4.DEF
REQUIREMENT VALUE OF COMBUSTION MODE isdis-
played.
Monitor item
Unit
Description
Remarks
DIAGNOSIS SYSTEM (ECM)
ECK-63
< SYSTEM DESCRIPTION >
[K9K]
C
D
E
F
G
H
I
J
K
L
M
A
ECK
N
P
O
EXH THRTL/ V CLSD POS LRN
NOT DONE/
DONE
Indicates Exhaust Throttle Valve Closed Position Learning
status.
ETAT PRIVE 5
1.DEF/2.DEF
Combustion mode - particulate filter regeneration authori-
zation state
INJ ERROR FIND PROCEDRE
1.DEF/2.DEF
Error detected by the monitoring of supplier injections (val-
ue after reset)
L/PRES EGR/V CLSD POS LRN
NOT DONE/
DONE
Indicates Low Pressure EGR Volume Control Valve Closed
Position Learning status.
LOW PRESSURE EGR VALVE
PROGRAMMING
UNAVAIL-
ABLE/AVAILBL
Low Pressure EGR Volume Control Valve Offset - first
learning running
STARTER BUTTON
PRESSED/
RELSD
Ignition switch status is displayed.
ENGAGE REVERSE GEAR
No/Yes
Selector lever “R” position status is displayed.
AUTOMATIC GEARBOX IN DE-
FECT MODE
Not detected/
DETCT
Transaxle in limp home mode is detected.
ACT SP INFO UNAV
Not detected/
DETCT
Real vehicle speed unavailable is detected.
VEHICLE SPEED DISPLAYED
UNAVAIL-
ABLE/AVAILBL
Displayed vehicle speed received on the CAN network not
available after a filtering time
VEHICLE SPEED MULTI-
PLEXED INFORMATION
UNAVAIL-
ABLE/AVAILBL
Vehicle speed received on the CAN network not available
after a filtering time
GEARBOX RATIO
DECLTC/1/2/3/
4/5/6/RVRS
Current gear engaged
• DECLTC: Declutched at rest
• 1: 1st gear
• 2: 2nd gear
• 3: 3rd gear
• 4: 4th gear
• 5: 5th gear
• 6: 6th gear
• RVRS: Reverse
FIRST START
NOT DONE/
DONE
First start status is displayed.
CLUTCH CONTACT MULTI-
PLEX SIGNAL
UNAVAIL-
ABLE/AVAILBL
Filtered unavailable clutch pedal status information
CLUTCH CONTACT WIRING -
START OF TRAVEL
UNAVAIL-
ABLE/AVAILBL
Begin stroke clutch pedal switch for cruise control safety
COMP + AFTER IGNITION
PRESENT/IN-
ACTIVE
Key state
A/C ATHRSTION
NOT DONE/
DONE/INAC-
TIVE
Air conditioning request
THERMOPLUNGER1 RELAY
DEACTIVAT/
ACTIVE/INAC-
TIVE
Thermoplungers command state
THERMOPLUNGER2 RELAY
DEACTIVAT/
ACTIVE/INAC-
TIVE
Thermoplungers command state
THERMOPLUNGER3 RELAY
DEACTIVAT/
ACTIVE/INAC-
TIVE
Thermoplungers command state
BRAKE PEDAL
NO PRS/RE-
SERVED/
PRESSED/IN-
ACTIVE
Brake pedal - close active switch state
Monitor item
Unit
Description
Remarks
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст