Nissan Qashqai J11. Manual — part 1546
BRM-12
< PRECAUTION >
[FOR EUROPE (LHD)]
REPAIRING HIGH STRENGTH STEEL
• Follow the specifications for the proper welding pitch.
Unit: mm (in)
Thickness (T)
Minimum pitch (L)
0.6 (0.024)
0.8 (0.031)
1.0 (0.039)
1.2 (0.047)
1.6 (0.063)
1.8 (0.071)
10 (0.39) or more
12 (0.47) or more
18 (0.71) or more
20 (0.79) or more
27 (1.06) or more
31 (1.22) or more
JSKIA0781ZZ
REPAIRING MATERIAL
BRM-13
< PREPARATION >
[FOR EUROPE (LHD)]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
PREPARATION
REPAIRING MATERIAL
Foam Repair
INFOID:0000000010287974
During factory body assembly, foam insulators are installed in certain body panels and locations around the
vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available Urethane foam for sealant (foam material) repair of material used on vehicle.
Read instructions on product for fill procedures.
Example of foaming agent filling operation procedure
1.
Fill procedures after installation of service part.
a.
Eliminate foam material remaining on vehicle side.
b.
Clean area after eliminating form insulator and foam material.
c.
Install service part.
d.
Insert nozzle into hole near fill area and fill foam material or fill enough to close gap with the service part.
2.
Fill procedures before installation of service part.
a.
Eliminate foam material remaining on vehicle side.
b.
Clean area after eliminating foam insulator and foam material.
c.
Fill foam material on wheelhouse outer side.
<Urethane foam for foaming agent>
3M™ Automix™ Flexible Foam 08463 or equiva-
lent
Urethane foam
Nozzle insert hole
: Vehicle front
JSKIA0129GB
BRM-14
< PREPARATION >
[FOR EUROPE (LHD)]
REPAIRING MATERIAL
NOTE:
Fill enough to close gap with service part while avoiding flange
area.
d.
Install service part.
NOTE:
Refer to label for information on working times.
Urethane foam
Fill while avoiding flange area
: Vehicle front
JSKIA0130GB
BODY COMPONENT PARTS
BRM-15
< PREPARATION >
[FOR EUROPE (LHD)]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
BODY COMPONENT PARTS
2WD
2WD : Ultra High Strength Steel Part
INFOID:0000000010505342
DESCRIPTION
Ultra high strength steel parts signify high strength steel plates with tensile strength of 980 MPa or more.
When replacing parts made of ultra high strength steel or parts including ultra high strength steel, never per-
form the prohibition described below:
PROHIBITION
WARNING:
Never cut ultra high strength steel parts or perform butt welding. Violation of this prohibition causes
extreme strength degradation, and the strength before damage cannot be secured.
PART REPLACEMENT
To replace an ultra high strength part, be sure to replace it by panel supply unit of ultra high strength steel part.
For the welding method, refer to
BRM-48, "Welding of Ultra High Strength Steel"
2WD : Underbody Component Parts
INFOID:0000000010287975
Refer to parts catalogue for the replacement parts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст