Nissan Qashqai J11. Manual — part 1725
SYSTEM
EXL-201
< SYSTEM DESCRIPTION >
[HALOGEN HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
• BCM turns the exterior lamp* OFF, according to the vehicle status when ignition switch is turned OFF while
exterior lamp is ON, for preventing battery discharge.
*: Headlamp (LO/HI), front fog lamp, rear fog lamp, parking lamp, license plate lamp and tail lamp
EXTERIOR LAMP BATTERY SAVER ACTIVATION
• BCM turns the exterior lamps OFF (battery saver is activated) when all of the following conditions are satis-
fied.
- Exterior lamp: ON
- Engine status: Running
→
Stop (ignition switch is turned OFF)
- Front door switch (driver side): OFF
→
ON
NOTE:
When in any of following conditions (after the exterior lamp battery saver is activated), exterior lamps [except
front fog lamp (with rear fog lamp) and rear fog lamp] can be turned ON.
• Lighting switch: 1ST or 2ND
→
OFF or AUTO
→
1ST or 2ND
• Engine status: Stop
→
Running
EXL-202
< SYSTEM DESCRIPTION >
[HALOGEN HEADLAMP]
DIAGNOSIS SYSTEM (BCM)
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
INFOID:0000000010469906
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
×
: Applicable item
NOTE:
*: This item is displayed, but not used.
FREEZE FRAME DATA (FFD)
The BCM records the following vehicle condition at the time a particular DTC is detected, and displays on
CONSULT.
Diagnosis mode
Function Description
Work Support
Changes the setting for each system function.
Self Diagnostic Result
Displays the diagnosis results judged by BCM.
CAN Diag Support Monitor
Monitors the reception status of CAN communication viewed from BCM.
Data Monitor
The BCM input/output signals are displayed.
Active Test
The signals used to activate each device are forcibly supplied from BCM.
Ecu Identification
The BCM part number is displayed.
Configuration
• Read and save the vehicle specification.
• Write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
Work Support
Data Monitor
Active Test
Door lock
DOOR LOCK
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Exterior lamp
HEAD LAMP
×
×
×
Interior room lamp control
INT LAMP
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
—
AIR CONDITONER*
×
×
Intelligent Key system
INTELLIGENT KEY
×
×
×
Combination switch
COMB SW
×
Body control system
BCM
×
NVIS - NATS
IMMU
×
Interior room lamp battery saver
BATTERY SAVER
×
Back door open
TRUNK
×
Vehicle security
THEFT ALM
×
×
RAP
RETAINED PWR
×
Remote keyless entry system
MULTI REMOTE ENT
×
×
Signal buffer system
SIGNAL BUFFER
×
×
DIAGNOSIS SYSTEM (BCM)
EXL-203
< SYSTEM DESCRIPTION >
[HALOGEN HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
HEADLAMP
HEADLAMP : CONSULT Function (BCM - HEAD LAMP) (Halogen Headlamp)
INFOID:0000000010469907
WORK SUPPORT
*
1
: For models without auto light system, this item is displayed, but cannot be used.
*
2
: Factory setting
DATA MONITOR
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
CONSULT screen item
Indication/Unit
Description
BATTERY VOLTAGE
V
Battery voltage of the moment a particular DTC is detected.
VEHICLE SPEED
km/h
Vehicle speed of the moment a particular DTC is detected.
EXTERNAL TEMP
°
C
External temperature of the moment a particular DTC is detected
VEHICLE COND
—
NOTE:
This item is displayed, but cannot be use this item.
DOOR LOCK STATUS
—
NOTE:
This item is displayed, but cannot be use this item.
POWER SUPPLY
COUNTER
min
Displays the cumulative time from the time that the battery terminal is connected.
Service item
Setting item
Setting
CUSTOM A/LIGHT SET-
TING*
1
MODE 1*
2
Normal
MODE 2
More sensitive setting than normal setting. (Turns ON earlier than normal op-
eration.)
MODE 3
More sensitive setting than MODE 2. (Turns ON earlier than MODE 2.)
MODE 4
Less sensitive setting than normal setting. (Turns ON later than normal oper-
ation.)
TWILIGHT On
MODE 1
NOTE:
This item is displayed, but cannot be used.
MODE 2
WIPER LINK
MODE 1
NOTE:
This item is displayed, but cannot be used.
MODE 2
MODE 3
MODE 4
Monitor item
[Unit]
Description
PUSH SW
[On/Off]
Indicates [On/Off] condition of push-button ignition switch
ENGINE STATE
[STOP/STALL/CRANK/RUN]
Indicates [STOP/STALL/CRANK/RUN] condition of engine states
VEH SPEED 1
[km/h]
Indicates [km/h] condition of vehicle speed signal from combination meter
EXL-204
< SYSTEM DESCRIPTION >
[HALOGEN HEADLAMP]
DIAGNOSIS SYSTEM (BCM)
*
1
: For models without auto light system, this item is displayed, but cannot be monitored.
*
2
: For models without front fog lamp, this item is displayed, but cannot be monitored.
*
3
: For models without rear fog lamp, this item is displayed, but cannot be monitored.
ACTIVE TEST
TURN SIGNAL R
[On/Off]
Each switch status that BCM judges from the combination switch reading function.
TURN SIGNAL L
[On/Off]
TAIL LAMP SW
[On/Off]
HI BEAM SW
[On/Off]
HEADLAMP SW
[On/Off]
LIGHT OFF SW
[On/Off]
PASSING SW
[On/Off]
AUTO LIGHT SW*
1
[On/Off]
FR FOG SW*
2
[On/Off]
RR FOG SW*
3
[On/Off]
DOOR SW-DR
[On/Off]
Indicated [On/Off] condition of front door switch (driver side)
DOOR SW-AS
[On/Off]
Indicated [On/Off] condition of front door switch (passenger side)
DOOR SW-RR
[On/Off]
Indicated [On/Off] condition of rear door switch RH
DOOR SW-RL
[On/Off]
Indicated [On/Off] condition of rear door switch LH
DOOR SW-BK
[On/Off]
Indicated [On/Off] condition of back door switch
OPTI SEN (DTCT)
[V]
NOTE:
This item is displayed, but cannot be monitored.
OPTI SEN (FILT)
[V]
NOTE:
This item is displayed, but cannot be monitored.
OPTICAL SENSOR*
1
[On/Off/NG]
The sensor condition received from light & rain sensor
Monitor item
[Unit]
Description
Test item
Operation
Description
FR FOG LAMP*
1
On
Transmits the front fog light request signal to IPDM E/R using CAN com-
munication to turn the front fog lamp ON.
Off
Stops the front fog light request signal transmission.
RR FOG LAMP*
2
On
Outputs voltage to turn the rear fog lamp ON.
Off
Stops the voltage to turn the rear fog lamp OFF.
STOP LAMP 1
On
Outputs voltage to turn the stop lamp RH ON.
Off
Stops the voltage to turn the stop lamp RH OFF.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст