Nissan Qashqai J11. Manual — part 1541
EXT-38
< REMOVAL AND INSTALLATION >
ROOF SIDE MOLDING
ROOF SIDE MOLDING
Exploded View
INFOID:0000000010377917
Removal and Installation
INFOID:0000000010377918
REMOVAL
1.
Open back door.
2.
Using suitable tool, release roof side molding fixing clips from
rear to front, then remove roof side molding.
CAUTION:
Always use shop cloth to avoid damaging the vehicle.
INSTALLATION
Install in the reverse order of removal.
WEATHERSTRIP-ROOF DRIP SEAL
REMOVAL
1.
Remove weatherstrip-roof drip seal by releasing clips.
1.
Roof side molding
2.
Roof side molding clip
3.
Roof side molding fastener
4.
Weatherstrip-roof drip seal
E1KIA0131ZZ
E1KIA0024ZZ
ROOF SIDE MOLDING
EXT-39
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
INSTALLATION
Install in the reverse order of removal.
1.
Clean the mating surface with an isopropanel spirit wipe to remove any grease or dirt on the weatherstrip-
roof drip seal.
2.
Fit clips on the body then apply pressure to the adhesive tape on the back of the weatherstrip drip seal.
CAUTION:
A new part must be fitted if removed, to make sure a good water seal.
EXT-40
< REMOVAL AND INSTALLATION >
ROOF RAIL
ROOF RAIL
Exploded View
INFOID:0000000010377919
Removal and Installation
INFOID:0000000010377920
REMOVAL
CAUTION:
Before removal, turn ignition switch OFF, disconnect both battery cables, and then wait for at least 3
minutes.
1.
Open back door.
2.
Partially remove headlining. Refer to
INT-25, "Removal and Installation"
3.
Remove roof rail assembly rear nut.
4.
Remove plastic cap and then remove roof rail assembly center nuts.
5.
Remove roof rail assembly front nuts.
6.
Remove roof rail assembly.
INSTALLATION
Install in the reverse order of removal.
1.
Roof rail assembly
E1KIA0120ZZ
DOOR SASH MOLDING
EXT-41
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
DOOR SASH MOLDING
Exploded View
INFOID:0000000010377923
Removal and Installation
INFOID:0000000010377924
REMOVAL
REAR DOOR SASH MOLDING
1.
Pull rear door sash molding (A) from upper side to lower side.
NOTE:
If necessary, use a flat screwdriver.
CAUTION:
Always use shop cloth to avoid damaging the vehicle.
2.
Remove rear door sash molding.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Always clean body and parts before installation.
1.
Rear door panel
2.
Front door panel
3.
Rear door sash tape
4.
Rear door sash molding
5.
Front door sash molding seal
6.
Front door sash tape
E1JIA0311ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст