Nissan Qashqai J11. Manual — part 750
P0966 PRESSURE CONTROL SOLENOID B
TM-575
< DTC/CIRCUIT DIAGNOSIS >
[CVT: RE0F10G]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
NO
>> There is malfunction of primary pressure solenoid valve. Replace transaxle assembly. Refer to
TM-576
< DTC/CIRCUIT DIAGNOSIS >
[CVT: RE0F10G]
P0967 PRESSURE CONTROL SOLENOID B
P0967 PRESSURE CONTROL SOLENOID B
DTC Logic
INFOID:0000000010245649
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
1.
Start the engine and wait for 5 seconds or more.
2.
Check the first trip DTC.
Is “P0967” detected?
YES
>> Go to
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000010245650
1.
CHECK CIRCUIT BETWEEN TCM AND CVT UNIT
1.
Turn ignition switch OFF.
2.
Disconnect TCM connector and CVT unit connector.
3.
Check continuity between TCM harness connector terminal and ground.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace damaged parts.
2.
CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND
Check continuity between CVT unit harness connector terminal and ground.
Is the inspection result normal?
YES >> Check
intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0967
PC SOLENOID B
(Pressure Control Solenoid B
Control Circuit High)
When all of the following conditions are satis-
fied and this state is maintained for 0.2 sec-
onds:
• TCM power supply voltage: More than 11 V
• P0966 is not detected
• TCM judges that solenoid valve circuit is
open.
• Harness or connector
(Primary pressure solenoid valve cir-
cuit open or shorted to power supply)
• Primary pressure solenoid valve
TCM
CVT unit
Continuity
Connector
Terminal
Connector
Terminal
F1
40
F58
2
Existed
CVT unit
—
Condition
Resistance
Connector
Terminal
F207
2
Ground
CVT fluid temperature: 20
°
C (68
°
F)
5.5 – 7.0
Ω
CVT fluid temperature: 50
°
C (122
°
F)
6.0 – 8.0
Ω
CVT fluid temperature: 80
°
C (176
°
F)
6.5 – 8.5
Ω
P0967 PRESSURE CONTROL SOLENOID B
TM-577
< DTC/CIRCUIT DIAGNOSIS >
[CVT: RE0F10G]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
NO
>> There is malfunction of primary pressure solenoid valve. Replace transaxle assembly. Refer to
TM-578
< DTC/CIRCUIT DIAGNOSIS >
[CVT: RE0F10G]
P1586 G SENSOR
P1586 G SENSOR
DTC Logic
INFOID:0000000010249638
DTC DETECTION LOGIC
NOTE:
DC stands for “DRIVING CYCLE” and indicates a series of driving cycle of “Ignition switch OFF
→
ON
→
driv-
ing
→
OFF”.
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.
PREPARATION BEFORE WORK
If another “DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT
1.
Start the engine.
2.
Drive the vehicle for 5 seconds or more.
3.
Stop the vehicle.
CAUTION:
Never stop the engine.
4.
Repeat step 2 through 3.
5.
Check the DTC.
“P1586”detected?
YES
>> Go to
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000010249639
1.
CHECK G SENSOR SIGNAL
With CONSULT
1.
Park the vehicle on a level surface.
2.
Turn ignition switch ON.
3.
Select “Data Monitor” in “TRANSMISSION”
4.
Select “G SEN SLOPE”.
5.
Swing the vehicle and check if value varies between
−
40.45% and 40.45%.
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P1586
G Sensor Circuit Electrical
When 1 or 2 is satisfied and maintained for 5 seconds or
more, and this state is satisfied two times within the same
DC:
1.
When all of the following conditions are satisfied:
-
G sensor detection voltage: 0.675 V or less
-
TCM power supply voltage: More than 11 V
2.
When all of the following conditions are satisfied:
-
G sensor detection voltage: 3.13 V or more
-
TCM power supply voltage: More than 11 V
• Harness or connector
(G sensor circuit)
• G sensor
Monitor item
Condition
Standard
G SEN SLOPE
Flat road
0%
Uphill
Positive value (Maximum 40.45%)
Downhill
Negative value (Minimum
−
40.45%)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст