Nissan Qashqai J11. Manual — part 2144
AV
USB INTERFACE AND AUX IN JACK
AV-265
< REMOVAL AND INSTALLATION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
USB INTERFACE AND AUX IN JACK
Removal and Installation
INFOID:0000000010435748
REMOVAL
1.
Remove center console. Refer to
2.
Release the pawls (A) on the back of USB interface and AUX in
jack (2).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1582ZZ
AV-266
< REMOVAL AND INSTALLATION >
[NAVIGATION]
MICROPHONE
MICROPHONE
Removal and Installation
INFOID:0000000010435749
REMOVAL
1.
Remove the map lamp assembly. Refer to
2.
Release harness connector (A) by sliding rearward to remove
from the pawl (B).
3.
Release pawls (C) and remove the microphone (1) from the
front room/map lamp assembly.
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1583ZZ
AV
AROUND VIEW MONITOR CONTROL UNIT
AV-267
< REMOVAL AND INSTALLATION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
AROUND VIEW MONITOR CONTROL UNIT
Exploded View
INFOID:0000000010435750
Removal and Installation
INFOID:0000000010435751
REMOVAL
CAUTION:
Before replacing around view monitor control unit, save or print current vehicle specification with
CONSULT configuration before replacement. Refer to
AV-177, "ADDITIONAL SERVICE WHEN
REPLACING AROUND VIEW MONITOR CONTROL UNIT : Work Procedure"
1.
Remove glove box assembly. Refer to
.
2.
Remove around view monitor control unit screws.
3.
Disconnect the harness connector from the around view monitor control unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Replace the around view monitor control unit if it has been dropped or sustained an impact.
• When replacing around view monitor control unit, you must perform "After Replace ECU" with CON-
SULT. Refer to
AV-177, "ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW MONITOR CON-
.
NOTE:
Perform camera image calibration. Refer to
AV-181, "CALIBRATING CAMERA IMAGE (AROUND VIEW
.
ALNIA1600ZZ
1.
Around view monitor control unit A.
Harness connector
AV-268
< REMOVAL AND INSTALLATION >
[NAVIGATION]
FRONT CAMERA
FRONT CAMERA
Exploded View
INFOID:0000000010435752
Removal and Installation
INFOID:0000000010435753
REMOVAL
1.
Remove the front grille. Refer to
2.
Remove screws and front camera.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
Perform camera image calibration. Refer to
AV-181, "CALIBRATING CAMERA IMAGE (AROUND VIEW
.
1.
Front grille
2.
Front camera
ALNIA1612ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст