Nissan Qashqai J11. Manual — part 830
PREPARATION
FAX-7
< PREPARATION >
[2WD]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
Sliding hammer
Removing drive shaft
Power tool
Loosening nuts, screws and bolts
Tool name
Description
ZZA0023D
PIIB1407E
FAX-8
< PERIODIC MAINTENANCE >
[2WD]
FRONT WHEEL HUB AND KNUCKLE
PERIODIC MAINTENANCE
FRONT WHEEL HUB AND KNUCKLE
Exploded View
INFOID:0000000010297294
.
Inspection
INFOID:0000000010297295
MOUNTING INSPECTION
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.
WHEEL BEARING INSPECTION
• Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of
wheel bearing.
• Rotate wheel hub and make sure there is no unusual noise or other irregular conditions. If there is any irreg-
ular condition, replace wheel hub and bearing assembly.
Standard
Axial end play
: Refer to
.
FRONT DRIVE SHAFT
FAX-9
< PERIODIC MAINTENANCE >
[2WD]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
FRONT DRIVE SHAFT
Inspection
INFOID:0000000010297296
• Check drive shaft mounting point and joint for looseness and other damage.
• Check boot for cracks and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
FAX-10
< REMOVAL AND INSTALLATION >
[2WD]
FRONT WHEEL HUB AND KNUCKLE
REMOVAL AND INSTALLATION
FRONT WHEEL HUB AND KNUCKLE
Exploded View
INFOID:0000000010297297
Removal and Installation
INFOID:0000000010297298
REMOVAL
Wheel Hub and Bearing Assembly
1.
Remove tires from vehicle.
2.
Remove wheel sensor from steering knuckle. Refer to
138, "FRONT WHEEL SENSOR : Exploded View"
CAUTION:
• Failure to separate the front wheel sensor from the streer-
ing knucklemay result in damage to the front wheel sen-
sor.
• Pull out the front wheel sensor, being careful to turn it as
little it possible. Do not pull on wheel sensor harness.
3.
Remove lock plate from strut assembly. Refer to
BR-19, "FRONT : Exploded View"
(LHD),
4.
Remove torque member mounting bolts. Hang torque member not to interfere with work. Refer to
"BRAKE CALIPER ASSEMBLY : Exploded View"
(LHD),
BR-80, "BRAKE CALIPER ASSEMBLY :
(RHD).
CAUTION:
Never depress brake pedal while brake caliper is removed.
1.
Steering knuckle
2.
Splash guard
3.
Wheel hub and bearing assembly
4.
Cotter pin
Refer to
for symbols in the figure.
E1DIA0224GB
ALDIA0526ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст