Nissan Maxima. Manual — part 65
AV-80
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
SUBWOOFER AMP
SUBWOOFER AMP
Removal and Installation
INFOID:0000000009471203
REMOVAL
1. Disconnect the battery negative terminal. Refer to
PG-67, "Removal and Installation (Battery)"
2. Remove the parcel shelf finisher. Refer to
INT-28, "Removal and Installation"
NOTE:
The subwoofer amp. can be removed without removing the parcel amp finisher. If moving the subwoofer
amp. and bracket, it is necessary to remove the parcel shelf finisher.
3. Remove the trunk upper finisher. Refer to
.
4. Remove the subwoofer amp. screws.
5. Disconnect the harness connectors from the subwoofer amp. and remove.
INSTALLATION
Installation is in the reverse order of removal.
1.
Subwoofer amp. and bracket
A.
Subwoofer amp. bracket screws
ALNIA1136ZZ
AV
STEERING SWITCH
AV-81
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
STEERING SWITCH
Removal and Installation
INFOID:0000000009471204
REMOVAL
1. Remove the driver airbag module. Refer to
SR-12, "Removal and Installation"
.
2. Remove the steering wheel audio control switch screws (A).
3. Release the steering wheel audio control switch harness clips
(B).
4. Remove the steering wheel audio control switches (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1132ZZ
AV-82
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
AUDIO ANTENNA
AUDIO ANTENNA
Location of Antenna
INFOID:0000000009471205
Window Antenna Repair
INFOID:0000000009471206
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on
each side.
• When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
ALNIA1213ZZ
1.
Audio unit
2.
Audio unit antenna feeder
3.
In-line connectors M103, M501
4.
Antenna amp.
5.
Window antenna
SEL250I
SEL122R
AV
AUDIO ANTENNA
AV-83
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
NOTE:
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
SEL252I
SEL253I
PIIA0215E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст