Nissan Maxima. Manual — part 571
EXL-26
< SYSTEM DESCRIPTION >
[XENON TYPE]
DIAGNOSIS SYSTEM (BCM)
HEADLAMP : CONSULT Function (BCM - HEAD LAMP)
INFOID:0000000010069549
DATA MONITOR
ACTIVE TEST
WORK SUPPORT
Monitor Item [Unit]
Description
PUSH SW [On/Off]
Indicates condition of push button ignition switch
ENGINE STATE [Stop/Stall/Crank/Run]
Indicates engine status received from ECM on CAN communication line
VEH SPEED 1 [km/h]
Indicates vehicle speed signal received from ABS on CAN communication line
KEY SW -SLOT [On/Off]
Indicates condition of key slot
TURN SIGNAL R [On/Off]
Indicates condition of combination switch
TURN SIGNAL L [On/Off]
TAIL LAMP SW [On/Off]
HI BEAM SW [On/Off]
HEAD LAMP SW 1 [On/Off]
HEAD LAMP SW 2 [On/Off]
PASSING SW [On/Off]
AUTO LIGHT SW [On/Off]
FR FOG SW [On/Off]
DOOR SW-DR [On/Off]
Indicates condition of front door switch LH
DOOR SW-AS [On/Off]
Indicates condition of front door switch RH
DOOR SW-RR [On/Off]
Indicates condition of rear door switch RH
DOOR SW-RL [On/Off]
Indicates condition of rear door switch LH
DOOR SW-BK [On/Off]
Indicates condition of trunk switch
OPTICAL SENSOR [V]
Indicates voltage signal from optical sensor
Test Item
Description
TAIL LAMP
This test is able to check tail lamp operation [On/Off].
HEAD LAMP
This test is able to check head lamp operation [Hi/Low/Off].
FR FOG LAMP
This test is able to check front fog lamp operation [On/Off].
DAYTIME RUNNING LIGHT
This test is able to check daytime running light operation [LH/RH/Off].
ILL DIM SIGNAL
This test is able to check head lamp illumination dimming operation [On/Off].
Support Item
Setting
Description
CUSTOM A/LIGHT SETTING
MODE 4
Less sensitive setting than normal setting (Turns ON later than
normal operation.)
MODE 3
More sensitive setting than MODE 2 (Turns ON earlier than MODE
2.)
MODE 2
More sensitive setting than normal setting (Turns ON earlier than
normal operation.)
MODE 1*
Normal
BATTERY SAVER SET
On*
Exterior lamp battery saver function ON
Off
Exterior lamp battery saver function OFF
DIAGNOSIS SYSTEM (BCM)
EXL-27
< SYSTEM DESCRIPTION >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
* : Initial setting
FLASHER
FLASHER : CONSULT Function (BCM - FLASHER)
INFOID:0000000010069550
DATA MONITOR
ACTIVE TEST
WORK SUPPORT
* : Initial setting
COMB SW
COMB SW : CONSULT Function (BCM-COMB SW)
INFOID:0000000010069551
DATA MONITOR
ILL DELAY SET
MODE 8
180 sec.
Sets delay timer function operation time
(All doors closed)
MODE 7
150 sec.
MODE 6
120 sec.
MODE 4
60 sec.
MODE 5
90 sec.
MODE 3
30 sec.
MODE 2
OFF
MODE 1* 45 sec.
Support Item
Setting
Description
Monitor Item [Unit]
Description
REQ SW -DR [On/Off]
Indicates condition of door request switch LH
REQ SW -AS [On/Off]
Indicates condition of door request switch RH
PUSH SW [On/Off]
Indicates condition of push button ignition switch
TURN SIGNAL R [On/Off]
Indicates condition of turn signal function of combination switch
TURN SIGNAL L [On/Off]
HAZARD SW [On/Off]
Indicates condition of hazard switch
RKE-LOCK [On/Off]
Indicates condition of lock signal from Intelligent Key
RKE-UNLOCK [On/Off]
Indicates condition of unock signal from Intelligent Key
RKE-PANIC [On/Off]
Indicates condition of panic alarm signal from Intelligent Key
Test Item
Description
FLASHER
This test is able to check turn signal lamp operation [Off/LH/RH].
Support Item
Setting
Description
HAZARD ANSWER BACK
Lock/Unlock*
Hazard warning lamp activation when doors are locked or unlocked with
the Intelligent Key.
Unlock Only
Hazard warning lamp activation when doors are unlocked with the Intelli-
gent Key.
Lock Only
Hazard warning lamp activation when doors are locked with the Intelligent
Key.
Off
No hazard warning lamp activation when doors are locked or unlocked
with the Intelligent Key.
EXL-28
< SYSTEM DESCRIPTION >
[XENON TYPE]
DIAGNOSIS SYSTEM (BCM)
BATTERY SAVER
BATTERY SAVER : CONSULT Function (BCM - BATTERY SAVER)
INFOID:0000000010069552
DATA MONITOR
ACTIVE TEST
WORK SUPPORT
Monitor Item [Unit]
Description
FR WIPER HI [On/Off]
Indicates condition of wiper operation of combination switch
FR WIPER LOW [On/Off]
FR WASHER SW [On/Off]
FR WIPER INT [On/Off]
FR WIPER STOP [On/Off]
Indicates front wiper auto stop signal received from IPDM E/R on CAN communication line
INT VOLUME [1 - 7]
Indicates condition of intermittent wiper operation of combination switch
TURN SIGNAL R [On/Off]
Indicates condition of right turn signal operation of combination switch
TURN SIGNAL L [On/Off]
Indicates condition of left turn signal operation of combination switch
TAIL LAMP SW [On/Off]
Indicates condition of tail lamp switch operation of combination switch
HI BEAM SW [On/Off]
Indicates condition of Hi beam switch operation of combination switch
HEAD LAMP SW 1 [On/Off]
Indicates condition of head lamp switch 1 operation of combination switch
HEAD LAMP SW 2 [On/Off]
Indicates condition of head lamp switch 2 operation of combination switch
PASSING SW [On/Off]
Indicates condition of passing switch operation of combination switch
AUTO LIGHT SW [On/Off]
Indicates condition of auto light switch operation of combination switch
FR FOG SW [On/Off]
Indicates condition of front fog lamp switch operation of combination switch
Monitor Item [Unit]
Description
REQ SW -DR [On/Off]
Indicates condition of door request switch LH
REQ SW -AS [On/Off]
Indicates condition of door request switch RH
PUSH SW [On/Off]
Indicates condition push button ignition switch
ACC RLY -F/B [On/Off]
Indicates condition of accessory relay
UNLK SEN -DR [On/Off]
Indicates condition of door unlock sensor
KEY SW -SLOT [On/Off]
Indicates condition of key slot
DOOR SW-DR [On/Off]
Indicates condition of front door switch LH
DOOR SW-AS [On/Off]
Indicates condition of front door switch RH
DOOR SW-RR [On/Off]
Indicates condition of rear door switch RH
DOOR SW-RL [On/Off]
Indicates condition of rear door switch LH
DOOR SW-BK [On/Off]
Indicates condition of trunk switch
CDL LOCK SW [On/Off]
Indicates condition of lock signal from door lock and unlock switch
CDL UNLOCK SW [On/Off]
Indicates condition of unlock signal from door lock and unlock switch
KEY CYL LK-SW [On/Off]
Indicates condition of lock signal from door key cylinder switch
KEY CYL UN-SW [On/Off]
Indicates condition of unlock signal from door key cylinder switch
TRNK/HAT MNTR [On/Off]
Indicates condition of trunk room lamp switch
RKE-LOCK [On/Off]
Indicates condition of lock signal from Intelligent Key
RKE-UNLOCK [On/Off]
Indicates condition of unlock signal from Intelligent Key
Test item
Description
BATTERY SAVER
This test is able to check battery saver operation [On/Off].
DIAGNOSIS SYSTEM (BCM)
EXL-29
< SYSTEM DESCRIPTION >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
* : Initial setting
Support Item
Setting
Description
ROOM LAMP BAT SAV SET
ON*
Interior room lamp battery saver function ON
OFF
Interior room lamp battery saver function OFF
ROOM LAMP TIMER SET
MODE 3*
10 min.
Sets interior room lamp battery saver timer operating time
MODE 2
60 min.
MODE 1
15 min.
BATTERY SAVER SET
ON*
Exterior lamp battery saver function ON
OFF
Exterior lamp battery saver function OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст