Nissan Maxima. Manual — part 751
HAC-180
< WIRING DIAGRAM >
[WITH MONOCHROME DISPLAY]
AIR CONDITIONER CONTROL
ABIIA1194GB
AIR CONDITIONER CONTROL
HAC-181
< WIRING DIAGRAM >
[WITH MONOCHROME DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
ABIIA1195GB
HAC-182
< WIRING DIAGRAM >
[WITH MONOCHROME DISPLAY]
AIR CONDITIONER CONTROL
ABIIA1196GB
INSUFFICIENT COOLING
HAC-183
< SYMPTOM DIAGNOSIS >
[WITH MONOCHROME DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
SYMPTOM DIAGNOSIS
INSUFFICIENT COOLING
Component Function Check
INFOID:0000000010051178
Symptom
• Insufficient cooling
• No cool air comes out. (Airflow volume is normal.)
INSPECTION FLOW
1.
CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE DECREASE
1. Press the AUTO switch.
2. Turn temperature control switch (driver side) counterclockwise until 18
°C (60°F) is displayed.
3. Check for cold air at discharge air outlets.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> GO TO 2
2.
CHECK FOR ANY SYMPTOMS
Perform a complete operational check and check for any symptoms. Refer to
.
Does another symptom exist?
YES
>> Refer to
HA-25, "WITH MONOCHROME DISPLAY : Symptom Matrix Chart"
NO
>> System OK.
3.
CHECK FOR SERVICE BULLETINS
Check for any service bulletins.
>> GO TO 4
4.
CHECK DRIVE BELTS
Check A/C compressor belt tension. Refer to
Is the inspection result normal?
YES
>> GO TO 5
NO
>> Adjust or replace A/C compressor belt. Refer to
EM-14, "Removal and Installation"
.
5.
CHECK SETTING OF TEMPERATURE SETTING TRIMMER
Using CONSULT, check the setting of “TEMP SET CORRECT” on “WORK SUPPORT” of HVAC. Refer to
HAC-109, "Temperature Setting Trimmer"
.
1. Check that the temperature setting trimmer is set to “+ direction”.
NOTE:
The control temperature can be set with the setting of the temperature setting trimmer.
2. Set temperature control dial to “0”.
Is the symptom still present?
YES
>> GO TO 6.
NO
>> Inspection End.
6.
CHECK WITH SELF-DIAGNOSIS FUNCTION OF CONSULT
1. Using CONSULT, perform “SELF-DIAGNOSIS RESULTS” of HVAC.
2. Check if any DTC No. is displayed in the trouble diagnosis results.
NOTE:
If DTC is displayed along with DTC U1000 or U1010, first diagnose the DTC U1000 or U1010. Refer to
Is any DTC No. displayed?
YES
>> Perform diagnosis for the applicable DTC. Refer to
NO
>> GO TO 7.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст