Nissan Maxima. Manual — part 1041
FRONT SEAT
SE-137
< UNIT DISASSEMBLY AND ASSEMBLY >
[W/O CLIMATE CONTROLLED SEATS]
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
Assembly
Assembly is in the reverse order of disassembly.
• When installing the seatback trim, firmly push down while sliding
your hand along the seams as shown (arrow) to ensure the velcro
fasteners are fastened properly.
• Make sure the chute rod is properly positioned and installed as shown.
: Front
• Make sure the side air bag outer chute (7) is pulled over the side
air bag module (3) and the side air bag inner chute (4) is pulled
around the frame (2). Make sure there are no wrinkles and the
chutes are not folded, twisted or pinched.
(1) Seatback pad
(2) Frame
(3) Side air bag module
(4) Inner side air bag chute
(5) Chute rod
(6) Seatback board
(7) Outer chute
: Front
CAUTION:
• If a malfunction was detected by the air bag warning lamp, after repair or replacement of the mal-
function parts, reset the memory using self-diagnosis or CONSULT.
• After work is completed, check that no system malfunction is detected by air bag warning lamp.
• Make sure side air bag module shell is closed at all tabs and cushion of module is not exposed. Do
not reuse if the tab of shell is not secured.
• Always install new side air bag module attaching nuts and side air bag chute rod bolts.
ALJIA0656ZZ
ALJIA0654ZZ
ALJIA0655ZZ
SE-138
< UNIT DISASSEMBLY AND ASSEMBLY >
[W/O CLIMATE CONTROLLED SEATS]
FRONT SEAT
• Always route side air bag module harness in original location. Replace any deformed or damaged
clips with the same type and color. Always install clips in the original location on the harness.
• Smooth out all wrinkles during assembly.
• Inspect seatback pad, trim cover and trim cover chutes. Replace if damaged.
• Replace any deformed or damaged parts.
• Replace any deformed or damaged hog rings. Ensure any old hog ring pieces are removed from the
seat.
• Use only one hog ring in each designated location.
• Ensure hog rings are correctly fastened around both the seatback trim and seatback pad trim wires.
NOTE:
Use NISSAN standard hog rings and tools to assemble.
THIGH EXTENSION ASSEMBLY
Disassembly
1. Move the thigh extension assembly to the front most position
and release the trim cover clips (A).
2. Remove the trim and pad (B).
3. Cut the thigh extension tethers and drill out the upper rivets (A)
that connect the thigh extension tethers (B) to the thigh exten-
sion assembly (C).
4. Insert suitable tool into the thigh extension assembly top panel
and release the clip (A).
5. Pull the thigh extension handle and remove the thigh extension
assembly.
6. Drill out the lower rivets that connect the thigh extension tethers to the seat frame assembly.
Assembly
1. Replace the pad, trim and clips and to the thigh extension assembly.
ALIIA0330ZZ
ALIIA0353ZZ
ALIIA0331ZZ
FRONT SEAT
SE-139
< UNIT DISASSEMBLY AND ASSEMBLY >
[W/O CLIMATE CONTROLLED SEATS]
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
2. Rivet the thigh extension tethers to the seat frame assembly
mounting hole (A).
3. Align the thigh extension assembly on the top rail.
4. Lift the thigh extension handle and slide the thigh extension
assembly onto the seat.
5. Rivet the thigh extension tethers to the thigh extension assem-
bly mounting hole (A).
PASSENGER SIDE
ALIIA0354ZZ
ALIIA0332ZZ
ALIIA0355ZZ
SE-140
< UNIT DISASSEMBLY AND ASSEMBLY >
[W/O CLIMATE CONTROLLED SEATS]
FRONT SEAT
PASSENGER SIDE : Exploded View
INFOID:0000000009468178
Passenger Seat
AWJIA0926ZZ
1.
Seatback board
2.
Seatback board clips
3.
Headrest
4.
Seat harness
5.
Seat cushion inner finisher inside (RH) 6.
Recline device inner cover
7.
Seat cushion outer finisher (RH) 8.
Seat recline knob
9.
Seat slide and lifter switch knob
10.
Power seat switch
11.
Seat cushion assembly
12. Seat cushion front finisher
13.
Front slide cover
14.
Seat frame assembly
15. Seat cushion outer finisher (LH)
16
Recline mechanism inner cover
17.
Seat cushion inner finisher inside (LH) 18. Seat belt buckle
19.
Seatback assembly
20.
Seatback pad
21. Seatback trim
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст