Nissan Maxima. Manual — part 828
PRECAUTIONS
LU-3
< PRECAUTION >
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
1. Remove old liquid gasket adhering to the liquid gasket applica-
tion surface and the mating surface, using scraper.
• Remove liquid gasket completely from the groove of the liquid
gasket application surface, bolts, and bolt holes.
2. Thoroughly clean the mating surfaces and remove adhering
moisture, grease and foreign materials.
3. Attach liquid gasket tube to Tool.
Use Genuine RTV Silicone Sealant or equivalent. Refer to
GI-21, "Recommended Chemical Products and Sealants"
.
4. Apply liquid gasket without breaks to the specified location with
the specified dimensions.
• If there is a groove for the liquid gasket application, apply liq-
uid gasket to the groove.
• As for the bolt holes, normally apply liquid gasket inside the
holes. Occasionally, it should be applied outside the holes.
Make sure to read the text of service manual.
• Within five minutes of liquid gasket application, install the mat-
ing component.
• If liquid gasket protrudes, wipe it off immediately.
• Do not retighten nuts or bolts after the installation.
• After 30 minutes or more have passed from the installation, fill
engine oil and engine coolant.
CAUTION:
Carefully follow all of the warnings, cautions, notes, and proce-
dures contained in this manual.
PBIC0003E
Tool number
: WS39930000 ( — )
WBIA0567E
SEM159F
LU-4
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009469243
The actual shapes of the tools may differ from those illustrated here.
Commercial Service Tool
INFOID:0000000009469244
Tool number
(TechMateNo.)
Tool name
Description
ST25051001
(J-25695-1)
Oil pressure gauge
Measuring oil pressure
Maximum measuring range: 2,452 kPa (25
kg-cm
2
, 356 psi)
ST25052000
(J-25695-2)
Hose
Adapting oil pressure gauge to upper oil pan
KV10115801
(J-38956)
Oil filter wrench
Removing and installing oil filter
KV10111100
(J-37228)
Seal cutter
Removing steel oil pan and rear timing chain
case
WS39930000
( — )
Tube presser
Pressing the tube of liquid gasket
NT050
S-NT559
S-NT772
S-NT046
NT052
PREPARATION
LU-5
< PREPARATION >
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
Tool name
Description
Deep socket
Removing and installing oil pressure switch
Deep socket 26 mm, 3/8 drive
Power tools
Loosening nuts, screws and bolts
NT818
PIIB1407E
LU-6
< SYSTEM DESCRIPTION >
LUBRICATION SYSTEM
SYSTEM DESCRIPTION
LUBRICATION SYSTEM
Lubrication Circuit
INFOID:0000000009469245
JPBIA1773GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст