Nissan Maxima. Manual — part 308
DRIVER SIDE DOOR MIRROR DEFOGGER
DEF-17
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
YES
>> GO TO 4
NO
>> Replace door mirror LH. Refer to
MIR-19, "Removal and Installation"
.
4.
CHECK INTERMITTENT INCIDENT
Check intermittent incident.
GI-41, "Intermittent Incident"
.
Is the inspection result normal?
YES
>> Check the following.
• Battery power supply circuit.
• Fuse block (J/B).
NO
>> Repair or replace the malfunctioning parts.
Component Inspection
INFOID:0000000010045593
1.
CHECK DOOR MIRROR DEFOGGER LH
1. Turn ignition switch OFF.
2. Disconnect door mirror LH.
3. Check continuity between door mirror terminals 5 and 13.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Replace door mirror LH. Refer to
Terminal Continuity
5
13
Yes
ALLIA0919ZZ
DEF-18
< DTC/CIRCUIT DIAGNOSIS >
PASSENGER SIDE DOOR MIRROR DEFOGGER
PASSENGER SIDE DOOR MIRROR DEFOGGER
Description
INFOID:0000000010045594
Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror
from fogging up.
Component Function Check
INFOID:0000000010045595
1.
CHECK DOOR MIRROR DEFOGGER RH
Check that the heating wire of door mirror defogger RH is heated when turning the rear window defogger
switch ON.
Is the inspection result normal?
YES
>> Door mirror defogger RH is OK.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000010045596
Regarding Wiring Diagram information, refer to
.
1.
CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door mirror RH.
3. Turn ignition switch ON.
4. Check voltage between door mirror RH harness connector D107
terminal 5 and ground.
Is the inspection result normal?
YES
>> GO TO 2
NO
>> Repair or replace harness.
2.
CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between door mirror RH harness connector
D107 terminal 13 and ground.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> Repair or replace harness.
3.
CHECK PASSENGER SIDE DOOR MIRROR DEFOGGER
Check door mirror defogger RH.
DEF-19, "Component Inspection"
Is the inspection result normal?
Terminals
Condition of rear
window defogger
switch
Voltage (V)
(Approx.)
(+)
(–)
Door mirror RH
connector
Terminal
D107
5
Ground
ON
Battery voltage
OFF
0
ALLIA0917ZZ
Door mirror RH connector
Terminal
Ground
Continuity
D107
13
Yes
ALLIA0918ZZ
PASSENGER SIDE DOOR MIRROR DEFOGGER
DEF-19
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
YES
>> GO TO 4
NO
>> Replace door mirror RH. Refer to
MIR-19, "Removal and Installation"
4.
CHECK INTERMITTENT INCIDENT
Check intermittent incident.
GI-41, "Intermittent Incident"
.
Is the inspection result normal?
YES
>> Check the following.
• Battery power supply circuit.
• Fuse block (J/B).
NO
>> Repair or replace the malfunctioning parts.
Component Inspection
INFOID:0000000010045597
1.
CHECK DOOR MIRROR DEFOGGER RH
1. Turn ignition switch OFF.
2. Disconnect door mirror RH.
3. Check continuity between door mirror terminals 5 and 13.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Replace door mirror RH. Refer to
.
Terminal Continuity
5
13
Yes
ALLIA0919ZZ
DEF-20
< ECU DIAGNOSIS INFORMATION >
BCM (BODY CONTROL MODULE)
ECU DIAGNOSIS INFORMATION
BCM (BODY CONTROL MODULE)
Reference Value
INFOID:0000000010065033
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
• Check Intelligent Key relative signal strength
• Confirm vehicle Intelligent Key antenna signal strength
VALUES ON THE DIAGNOSIS TOOL
Monitor Item
Condition
Value/Status
FR WIPER HI
Other than front wiper switch HI
OFF
Front wiper switch HI
ON
FR WIPER LOW
Other than front wiper switch LO
OFF
Front wiper switch LO
ON
FR WASHER SW
Front washer switch OFF
OFF
Front washer switch ON
ON
FR WIPER INT
Other than front wiper switch INT
OFF
Front wiper switch INT
ON
FR WIPER STOP
Front wiper is not in STOP position
OFF
Front wiper is in STOP position
ON
INT VOLUME
Wiper intermittent dial is in a dial position 1 - 7
Wiper intermittent dial position
TURN SIGNAL R
Other than turn signal switch RH
OFF
Turn signal switch RH
ON
TURN SIGNAL L
Other than turn signal switch LH
OFF
Turn signal switch LH
ON
TAIL LAMP SW
Other than lighting switch 1ST and 2ND
OFF
Lighting switch 1ST or 2ND
ON
HI BEAM SW
Other than lighting switch HI
OFF
Lighting switch HI
ON
HEAD LAMP SW 1
Other than lighting switch 2ND
OFF
Lighting switch 2ND
ON
HEAD LAMP SW 2
Other than lighting switch 2ND
OFF
Lighting switch 2ND
ON
PASSING SW
Other than lighting switch PASS
OFF
Lighting switch PASS
ON
AUTO LIGHT SW
Other than lighting switch AUTO
OFF
Lighting switch AUTO
ON
FR FOG SW
Front fog lamp switch OFF
OFF
Front fog lamp switch ON
ON
DOOR SW-DR
Driver door closed
OFF
Driver door opened
ON
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст