Nissan Leaf. Manual — part 944
PRECAUTIONS
MIR-3
< PRECAUTION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery and wait at least three minutes before performing any service.
Precaution for Removing 12V Battery
INFOID:0000000010122869
CAUTION:
When the 12V battery is removed, plural DTC may be detected.
After installing 12V battery, always perform “All DTC” with CONSULT and delete DTC.
MIR-4
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000010122870
The actual shape of the tools may differ from those illustrated here.
Commercial Service Tools
INFOID:0000000010122871
Tool number
(TechMate No.)
Tool name
Description
(J-39570)
Chassis Ear
Locates the noise
(J-50397)
NISSAN Squeak and Rattle
Kit
Repairs the cause of noise
—
(J-46534)
Trim Tool Set
Removing trim components
SIIA0993E
ALJIA1232ZZ
AWJIA0483ZZ
(TechMate No.)
Tool name
Description
(J-39565)
Engine Ear
Locates the noise
( — )
Power tool
Loosening nuts, screws and bolts
SIIA0995E
PIIB1407E
DOOR MIRROR
MIR-5
< WIRING DIAGRAM >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
WIRING DIAGRAM
DOOR MIRROR
Wiring Diagram
INFOID:0000000010122872
AALWA0820GB
MIR-6
< WIRING DIAGRAM >
DOOR MIRROR
AALIA2308GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст