Nissan Leaf. Manual — part 1243
NORMAL CHARGE PORT
VC-139
< REMOVAL AND INSTALLATION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
8. Pull out the normal charge port toward the rear of the vehicle.
WARNING:
Be sure to put on insulating protective gear before beginning work on the high voltage sys-
tem.
9. Remove the PDM (Power Delivery Module) before removing the normal charge port.
WARNING:
Be sure to put on insulating protective gear before beginning work on the high voltage sys-
tem.
INSTALLATION
Install in the reverse order of removal.
WARNING:
Be sure to put on insulating protective gear before beginning work on the high voltage system.
CAUTION:
Be sure to reinstall high-voltage harness clips in their original positions. If a clip is damaged, replace it
with a new clip before installing.
Disassembly and Assembly
INFOID:0000000010121301
DISASSEMBLY
Cover Side
1. Use a suitable tool (A) to remove the clip that is attached to
the pin.
JSCIA0219ZZ
VC-140
< REMOVAL AND INSTALLATION >
NORMAL CHARGE PORT
2. Pull out pin of charge port cover.
CAUTION:
When pin is pulled out, the spring will also jump out. Take
care not to lose it.
3. Remove damper from charge port cover.
Lever Side
1. Use a suitable tool (A) to remove the clip that is attached to
the pin.
2. Press while removing pin to ensure that spring does not
jump out, then remove lever.
ASSEMBLY
Note the following, and assemble in the reverse order of disassembly.
CAUTION:
• Never reuse the clips.
• Pay attention to direction that cover side damper is facing.
JSCIA0220ZZ
JSCIA0221ZZ
JSCIA0222ZZ
JSCIA0223ZZ
NORMAL CHARGE PORT
VC-141
< REMOVAL AND INSTALLATION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
• Pay attention to direction that spring is facing.
: Spring (large)
: Spring (small)
JSCIA0382ZZ
VC-142
< REMOVAL AND INSTALLATION >
CHARGE CONNECTOR LOCK ACTUATOR
CHARGE CONNECTOR LOCK ACTUATOR
Exploded View
INFOID:0000000010121302
REMOVAL
Removal and Installation
INFOID:0000000010121303
DANGER:
Since hybrid vehicles and electric vehicles contain a high voltage battery, there is the risk of
electric shock, electric leakage, or similar accidents if the high voltage component and vehicle are
handled incorrectly. Be sure to follow the correct work procedures when performing inspection and
maintenance.
WARNING:
• Be sure to remove the service plug in order to disconnect the high voltage circuits before perform-
ing inspection or maintenance of high voltage system harnesses and parts.
• The removed service plug must always be carried in a pocket of the responsible worker or placed in
the tool box during the procedure to prevent the plug from being connected by mistake.
• Be sure to wear insulating protective equipment consisting of glove, shoes, face shield and glasses
before beginning work on the high voltage system.
• Never allow workers other than the responsible person to touch the vehicle containing high voltage
parts. To keep others from touching the high voltage parts, these parts must be covered with an insu-
lating sheet except when using them.
Quick charge port
Charge port bracket
Normal charge port
Charge connector lock acutuator
: N·m (kg-m, in-lb)
JPCIA0318GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст