Nissan Leaf. Manual — part 386
DIAGNOSIS SYSTEM (BCM)
DLK-39
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)
INFOID:0000000010500888
SELF DIAGNOSTIC RESULT
DATA MONITOR
ACTIVE TEST
WORK SUPPORT
*: Initial setting
INTELLIGENT KEY
INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)
INFOID:0000000010500889
SELF DIAGNOSTIC RESULT
Monitor Item [Unit]
Description
REQ SW-DR [On/Off]
Indicates condition of door request switch LH.
REQ SW-AS [On/Off]
Indicates condition of door request switch RH.
REQ SW-BD/TR [On/Off]
Indicates condition of back door request switch.
DOOR SW-DR [On/Off]
Indicates condition of front door switch LH.
DOOR SW-AS [On/Off]
Indicates condition of front door switch RH.
DOOR SW-RR [On/Off]
Indicates condition of rear door switch RH.
DOOR SW-RL [On/Off]
Indicates condition of rear door switch LH.
DOOR SW-BK [On/Off]
Indicates condition of trunk switch.
CDL LOCK SW [On/Off]
Indicates condition of lock signal from door lock and unlock switch.
CDL UNLOCK SW [On/Off]
Indicates condition of unlock signal from door lock and unlock switch.
KEY CYL LK-SW [On/Off]
Indicates condition of lock signal from door key cylinder switch.
KEY CYL UN-SW [On/Off]
Indicates condition of unlock signal from door key cylinder switch.
Test Item
Description
DOOR LOCK
This test is able to check door lock operation [ALL LOCK/ALL UNLK/DR UNLK/AS UNLK/OTR
ULK].
Support Item
Setting
Description
DOOR LOCK-UNLOCK SET
On*
Selective unlock function ON.
Off
Selective unlock function OFF.
AUTOMATIC LOCK/UNLOCK SE-
LECT
Lock/Unlock*
Automatic door lock and unlock functions ON.
Lock Only
Automatic door lock only function ON.
Unlock Only
Automatic door unlock only function ON.
Off
Automatic door lock function OFF.
AUTOMATIC DOOR LOCK SELECT
P RANGE
Doors lock automatically when shifted out of P (park).
VH SPD
Doors lock automatically when vehicle speed is greater than 24 km/h (15 mph).
AUTOMATIC DOOR UNLOCK SE-
LECT
MODE6
This mode is not used.
MODE5
This mode is not used.
MODE4
Driver door is unlocked automatically when shifted into P (park).
MODE3
Driver door is unlocked automatically when ignition is switched from ON to OFF.
MODE2
All doors unlock automatically when shifted into P (park).
MODE1*
All doors unlock automatically when ignition is switched from ON to OFF.
DLK-40
< SYSTEM DESCRIPTION >
DIAGNOSIS SYSTEM (BCM)
DATA MONITOR
ACTIVE TEST
Monitor Item [Unit]
Main
Description
REQ SW -DR [On/Off]
×
Indicates condition of door request switch LH.
REQ SW -AS [On/Off]
×
Indicates condition of door request switch RH.
REQ SW -BD/TR [On/Off]
×
Indicates condition of back door request switch.
PUSH SW [On/Off]
Indicates condition of power switch.
BRAKE SW 1 [On/Off]
×
Indicates condition of brake switch.
BRAKE SW 2 [On/Off]
Indicates condition of brake switch.
DETE/CANCL SW [On/Off]
×
Indicates condition of P (park) position.
SFT PN/N SW [On/Off]
×
Indicates condition of P (park) or N (neutral) position.
UNLK SEN -DR [On/Off]
×
Indicates condition of door unlock sensor.
PUSH SW -IPDM [On/Off]
Indicates condition of power switch received from IPDM E/R on CAN commu-
nication line.
IGN RLY1 -F/B [On/Off]
Indicates condition of ignition relay 1 received from IPDM E/R on CAN commu-
nication line.
DETE SW -IPDM [On/Off]
Indicates condition of detent switch received from TCM on CAN communication
line.
SFT P -MET [On/Off]
Indicates condition of P (park) position from TCM on CAN communication line.
SFT N -MET [On/Off]
Indicates condition of N (neutral) position from IPDM E/R on CAN communica-
tion line.
ENGINE STATE [Stop/Start/Crank/Run]
×
Indicates condition of engine state from ECM on CAN communication line.
VEH SPEED 1 [mph/km/h]
×
Indicates condition of vehicle speed signal received from ABS on CAN commu-
nication line.
VEH SPEED 2 [mph/km/h]
×
Indicates condition of vehicle speed signal received from combination meter on
CAN communication line.
DOOR STAT -DR [LOCK/READY/UNLK]
×
Indicates condition of driver side door status.
DOOR STAT -AS [LOCK/READY/UNLK]
×
Indicates condition of passenger side door status.
ID OK FLAG [Set/Reset]
Indicates condition of Intelligent Key ID.
PRMT ENG STRT [Set/Reset]
Indicates condition of engine start possibility.
RKE OPE COUN1 [0-19]
×
When remote keyless entry receiver receives the signal transmitted while oper-
ating the Intelligent Key, the numerical value starts changing.
RKE-LOCK [On/Off]
Indicates condition of lock signal from Intelligent Key.
RKE-UNLOCK [On/Off]
Indicates condition of unlock signal from Intelligent Key.
RKE-PANIC [On/Off]
Indicates condition of panic signal from Intelligent Key.
RKE-MODE CHG [On/Off]
Indicates condition of mode change signal from Intelligent Key.
Test Item
Description
INSIDE BUZZER
This test is able to check combination meter warning chime operation [Off/Take Out/Knob/
Key].
DIAGNOSIS SYSTEM (BCM)
DLK-41
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
WORK SUPPORT
LCD
B&P N
This test is able to check combination meter traction motor start information.
B&P I
ID NG
This test is able to check combination meter key ID warning information.
ROTAT
This item is displayed, but is not used.
SFT P
INSRT
BATT
This test is able to check combination meter Intelligent Key low battery warning
information.
NO KY
This item is displayed, but is not used.
OUTKEY
This test is able to check combination meter take away warning information.
LK WN
This test is able to check combination meter OFF position warning information.
Off
—
BATTERY SAVER
This test is able to check interior room lamp battery saver operation [Off/On].
ENGINE SW ILLUMI
This test is able to check power switch illumination operation [Off/On].
PUSH SWITCH INDICATOR
This test is able to check power switch ACC/ON indicator operation [Off/On].
TRUNK/BACK DOOR
This test is able to check back door opener actuator operation [Open].
INT LAMP
This test is able to check interior room lamp operation [Off/On].
INDICATOR
This test is able to check combination meter warning lamp operation [Off/KEY ON/KEY IND].
FLASHER
This test is able to check security hazard lamp operation [RH/LH/Off].
OUTSIDE BUZZER
This test is able to check Intelligent Key warning buzzer operation [On/Off].
HORN
This test is able to check horn operation [On].
Test Item
Description
Support Item
Setting
Description
LOCK/UNLOCK BY I-KEY
On*
Door lock/unlock function from request switch ON.
Off
Door lock/unlock function from request switch OFF.
ANTI KEY LOCK IN-FUNCTI
On*
Key reminder function ON.
Off
Key reminder function OFF.
ANS BACK I-KEY UNLOCK
On*
Buzzer reminder function when doors are unlocked with request
switch ON.
Off
Buzzer reminder function when doors are unlocked with request
switch OFF.
ANS BACK I-KEY LOCK
Horn Chirp
Horn chirp reminder function when doors are locked with request
switch.
Buzzer*
Buzzer reminder function when doors are locked with request switch.
Off
No reminder function when doors are locked with request switch.
HORN WITH KEYLESS LOCK
On*
Horn reminder function when doors are locked with Intelligent Key
ON.
Off
Horn reminder function when doors are locked with Intelligent Key
OFF.
HAZARD ANSWER BACK
Lock/Unlock*
Horn reminder function when doors are locked or unlocked with re-
quest switch or Intelligent Key.
Unlock Only
Horn reminder function when doors are unlocked with request switch
or Intelligent Key.
Lock Only
Horn reminder function when doors are locked with request switch or
Intelligent Key.
Off
Horn reminder function when doors are locked or unlocked with re-
quest switch or Intelligent Key OFF.
DLK-42
< SYSTEM DESCRIPTION >
DIAGNOSIS SYSTEM (BCM)
*: Initial Setting
TRUNK
TRUNK : CONSULT Function (BCM - TRUNK)
INFOID:0000000010500890
DATA MONITOR
INSIDE ANT DIAGNOSIS
—
This function allows inside key antenna self-diagnosis.
CONFIRM KEY FOB ID
MEMORY 1
Intelligent Key ID code can be checked.
MEMORY 2
MEMORY 3
MEMORY 4
NON REGIST
PANIC ALARM SET
MODE 3
1.5 sec.
Panic alarm button set time on Intelligent Key can be set.
MODE 2
OFF
MODE 1*
0.5 sec.
AUTO LOCK SET
MODE7
5 min.
Auto door lock time can be set.
MODE6
4 min.
MODE5
3 min.
MODE4
2 min.
MODE3*
1 min.
MODE2
30 sec.
MODE1
OFF
Support Item
Setting
Description
Monitor Item [Unit]
Description
PUSH SW [On/Off]
Indicates condition of power switch.
UNLK SEN -DR [On/Off]
Indicates condition of door unlock sensor.
VEH SPEED 1 [km/h]
Indicates vehicle speed signal received from ABS on CAN communication line.
TR/BD OPEN SW [On/Off]
Indicates condition of back door opener switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст