Nissan Leaf. Manual — part 1213
SYSTEM
VC-19
< SYSTEM DESCRIPTION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
NOTE:
• When the battery temperature is ambient temperature, charging stops after approximately 30 minutes.
• When the battery temperature is low or high, charging stops after a maximum of 60 minutes.
• If charging stops before charging is complete, additional charging by quick charge can be performed again.
CHARGING STATUS INDICATOR AND CHARGING SOUND SYSTEM
The charge connector connection status and charge receiving status can be checked with the charging status
indicator and the electronic sound from the Vehicle Sound for Pedestrians (VSP).
• For charging status indicator, refer to
VC-15, "Charging Status Indicator"
.
• For charging sound system, refer to
VSP-22, "CHARGE SOUND SYSTEM : System Description"
CHARGE PORT CONTROL
CHARGE PORT CONTROL : System Description
INFOID:0000000010121214
DESCRIPTION
The full range of charge port control is performed by the VCM. This includes charge connector lock/unlock
control which automatically locks the charge connector during normal charging and at other times, and charge
port light control which automatically turns ON the LED illumination inside the port to improve charge port visi-
bility when the charge connector is inserted or removed.
CHARGE CONNECTOR LOCK/UNLOCK CONTROL
Function Description
Charge connector lock/unlock control automatically locks the charge connector according to the charging type
to prevent tampering during charging.
The VCM detects the status of the charge connector lock switch and charge port, and controls the charge con-
nector lock actuator according to the mode and vehicle conditions. For details of control, refer to
"CHARGE PORT CONTROL : System Description"
Lock Mode
Three lock modes can be selected according to the charging type. The mode can be changed by operating the
charge connector lock switch that is located on the switch panel on the left side of the driver's seat. The
selected mode can also be checked on the vehicle information display.
*: Also locks when only timer A/C, remote A/C, or de-ice control is operating.
Unlock
When the following operations are performed, the charge connector lock is temporarily released.
• Operation of the charge port lid opener button on the Intelligent Key
• Pressing of the charge port lid opener switch
CAUTION:
If the charge connector is not disconnected, it is locked again automatically after 30 seconds.
Operation Timing Chart
Control
Description
Charge connector lock/unlock control
Automatically locks and unlocks the charge connector when the normal charge con-
nector is connected and during normal charging.
Charge port light control
Automatically turns the LED lighting inside the charge port ON/OFF.
Charge port lid open control
Performs unlocking of the charge port lid.
Answer-back control
Checks operation of charge connector lock/unlock control.
Lock mode
(Switch position)
Basic operation
Lock
Unlock
LOCK mode
Normal charge connector is always locked when con-
nected.
Unlock operation
AUTO mode
Locked only during the period of time from start to end
of normal charging.
*
• When normal charging is completed
• Unlock operation
UNLOCK mode
(Neutral position)
Does not lock.
—
VC-20
< SYSTEM DESCRIPTION >
SYSTEM
• LOCK mode
• AUTO mode
*:Models with Li-ion battery heater
Operation Description
The swing arm of the charge port lock actuator fits into the latch
upper portion on the normal charge connector. This limits the move-
ment of the latch and locks the charge connector.
CAUTION:
The release switch cannot be pressed while the connector is
locked.
JSCIA0613GB
JSCIA0614GB
JSCIA0615GB
SYSTEM
VC-21
< SYSTEM DESCRIPTION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
CAUTION:
If the charge connector lock cannot be released, use a flat-bladed screwdriver or a similar tool to
release it manually.
Countermeasure In Case Of Charge Connector Lock/Unlock Control Malfunction
If the charge connector lock does not release automatically, perform the following procedure to release the
lock manually.
1. Open hood.
2. Insert a flat-bladed screwdriver or similar tool (A) into the radia-
tor grille upper hole , and turn the screw portion of the charge
connector lock actuator clockwise approximately 45
° to release
the charge connector lock.
CHARGE PORT LIGHT CONTROL
Function Description
Charge port light control automatically turns the LED illumination installed to inside of charge port lid ON and
OFF to improve workability during charging.
The VCM performs control for turning the charge port light ON/OFF according to the signal from the charge
port lid opener switch or the Intelligent Key charge port lid opener button, and according to the vehicle condi-
tions. For details of control, refer to
EVC-61, "CHARGE PORT CONTROL : System Description"
.
JSCIA0616GB
: Vehicle front
JSCIA0617ZZ
VC-22
< SYSTEM DESCRIPTION >
SYSTEM
Operation Timing Chart
CHARGE PORT LID OPEN CONTROL
Function Description
An electromagnetic charge port lid opener is adopted and unlocks the charge port lid (depending on the vehi-
cle conditions) using the charge port lid opener switch installed to the right instrument lower panel or the
charge port lid opener button on the Intelligent Key.
The VCM controls the charge port lid actuator according to the signal from the charge port lid opener switch or
the Intelligent Key charge port lid opener button. For control, refer to
EVC-61, "CHARGE PORT CONTROL :
.
NOTE:
If the lock cannot be released due to a fully discharged battery, malfunction of the charge port lid opener actu-
ator, or other reason, release the lock manually. Refer to
DLK-211, "Removal and Installation"
ANSWER-BACK CONTROL
Function Description
Answer-back control allows the unlock status of charge connector lock/unlock control to be checked using the
charging status indicator and the electronic sound from the Vehicle Sound for Pedestrians (VSP).
• For charging status indicator, refer to
VC-15, "Charging Status Indicator"
.
• For Vehicle Sound for Pedestrians, refer to
VSP-22, "CHARGE SOUND SYSTEM : System Description"
POWER VOLTAGE VARIABLE CONTROL SYSTEM
POWER VOLTAGE VARIABLE CONTROL SYSTEM : System Description
INFOID:0000000010121215
DESCRIPTION
Power voltage variable control reduces the electric power consumption from the Li-ion battery by varying the
DC/DC converter output in a range from 13 V to 15 V according to the use status of electric equipment and the
12V battery status.
For control, refer to
EVC-58, "POWER VOLTAGE VARIABLE CONTROL SYSTEM : System Description"
AUTOMATIC 12V BATTERY CHARGE CONTROL
AUTOMATIC 12V BATTERY CHARGE CONTROL : System Description
INFOID:0000000010121216
DESCRIPTION
JSCIA0618GB
Condition
Charging status indicator
Vehicle Sound for Pedestrians
(VSP)
Press the charge port lid opener switch or Intelligent Key
charge port lid opener button.
Three blinks
(All lamps)
Short beep
(Electronic sound sounds three
times.)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст