Nissan Leaf. Manual — part 1143
ELECTRONICALLY CONTROLLED POWER STEERING SYSTEM
STC-17
< WIRING DIAGRAM >
C
D
E
F
H
I
J
K
L
M
A
B
STC
N
O
P
AAGIA0144GB
STC-18
< WIRING DIAGRAM >
ELECTRONICALLY CONTROLLED POWER STEERING SYSTEM
AAGIA0145GB
ELECTRONICALLY CONTROLLED POWER STEERING SYSTEM
STC-19
< WIRING DIAGRAM >
C
D
E
F
H
I
J
K
L
M
A
B
STC
N
O
P
AAGIA0146GB
STC-20
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000010119193
DETAILED FLOW
1.
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing
and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints
carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION:
Customers are not professional. Never guess easily like “maybe the customer means that...,” or
“maybe the customer mentions this symptom”.
>> GO TO 2.
2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer
obtained by interview. Also check that the symptom is not caused by protection function. Refer to
CAUTION:
When the symptom is caused by normal operation, fully inspect each portion and obtain the under-
standing of customer that the symptom is not caused by a malfunction.
>> GO TO 3.
3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis.
Is any DTC detected?
YES
>> Record or print DTC and freeze frame data (FFD). GO TO 4.
NO
>> GO TO 6.
4.
RECHECK SYMPTOM
With CONSULT
1. Erase self-diagnostic results.
2. Perform DTC confirmation procedures for the malfunctioning system.
NOTE:
If some DTCs are detected at the same time, determine the order for performing the diagnosis based on
14, "DTC Inspection Priority Chart"
Is any DTC detected?
YES
>> GO TO 5.
NO
>> Check harness and connectors based on the information obtained by interview. Refer to
.
5.
REPAIR OR REPLACE MALFUNCTIONING PARTS
• Repair or replace malfunctioning parts.
• Reconnect part or connector after repairing or replacing.
• When DTC is detected, erase “Self-Diagnostic Result” for “EPS”.
>> GO TO 7.
6.
IDENTIFY MALFUNCTIONING SYSTEM BY SYMPTOM DIAGNOSIS
Estimate malfunctioning system based on symptom diagnosis and perform inspection.
Can the malfunctioning system be identified?
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст