Nissan Leaf. Manual — part 1019
PG-88
< BASIC INSPECTION >
FUSIBLE LINK INSPECTION
FUSIBLE LINK INSPECTION
How To Check
INFOID:0000000010119400
A melted fusible link can be detected either by visual inspection or by
feeling with finger tip. If its condition is questionable, use circuit
tester or test lamp.
CAUTION:
• If fusible link should melt, it is possible that critical circuit
(power supply or large current carrying circuit) is shorted. In
such a case, carefully check and eliminate cause of malfunc-
tion.
• Never wrap outside of fusible link with vinyl tape. Important:
Never let fusible link touch any other wiring harness, vinyl or
rubber parts.
1
:Fusible link
JSMIA0532ZZ
PG
12V BATTERY
PG-89
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
REMOVAL AND INSTALLATION
12V BATTERY
Exploded View
INFOID:0000000010119401
Removal and Installation
INFOID:0000000010119402
REMOVAL
1. Disconnect the 12V battery cable from the negative terminal. Refer to
PG-6, "Precaution for Removing
CAUTION:
To prevent damage to the parts, disconnect the 12V battery cable from the negative terminal first.
2. Remove cover of 12V battery positive terminal.
3. Disconnect the 12V battery cable from the positive terminal.
4. Remove battery frame nuts and battery frame.
5. Remove 12V battery.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install the 12V battery, carefully read the following instructions.
• To prevent damage to the parts, connect the 12V battery cable to the positive terminal first.
• After connecting 12V battery cables, to securely supply 12V battery voltage, ensure that they are
tightly clamped to 12V battery terminals for good contact.
• To securely supply 12V battery voltage, check 12V battery terminal for poor connection caused by
corrosion.
AWGIA0325ZZ
1.
Battery frame
2.
Battery rods
3.
Battery
4.
Battery tray liner
5.
Battery tray
6.
Battery tray bracket
Front
PG-90
< REMOVAL AND INSTALLATION >
12V BATTERY
Reset electronic systems as necessary. Refer to
PG
BATTERY TRAY
PG-91
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BATTERY TRAY
Exploded View
INFOID:0000000010119403
Removal and Installation
INFOID:0000000010119404
REMOVAL
1. Remove the 12 volt battery. Refer to
PG-89, "Removal and Installation"
.
2. Remove the battery tray liner.
3. Remove the ground strap retainers from the battery tray and set the ground strap aside.
4. Remove the fuse, fusible link and relay box-1 from the battery tray and set the fuse, fusible link and relay
box-1 aside.
5. Remove battery tray bolts and battery tray.
INSTALLATION
Installation is in the reverse order of removal.
AWGIA0325ZZ
1.
Battery frame
2.
Battery rods
3.
Battery
4.
Battery tray liner
5.
Battery tray
6.
Battery tray bracket
Front
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст