Nissan Murano. Manual — part 249
REPLACEMENT OPERATIONS
BRM-21
< REMOVAL AND INSTALLATION >
[FOR USA AND CANADA]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
REPLACEMENT OPERATIONS
Description
INFOID:0000000009718044
• This section is prepared for technicians who have attained a high level of skill and experience in repairing
collision-damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body
repair techniques should not attempt to repair collision-damaged vehicles by using this section.
• Technicians are also encouraged to read the Body Repair Manual (Fundamentals) in order to ensure that the
original functions and quality of the vehicle are maintained. The Body Repair Manual (Fundamentals) con-
tains additional information, including cautions and warnings, that are not including in this manual. Techni-
cians should refer to both manuals to ensure proper repair.
• Please note that this information is prepared for worldwide usage, and as such, certain procedures might not
apply in some regions or countries.
The symbols used in this section for welding operations are shown below.
Symbol marks
Description
2-spot welds
3-spot welds
MIG plug weld
For 3 panels plug weld method
MIG seam weld / Point weld
JSKIA0049ZZ
JSKIA0053ZZ
JSKIA0050ZZ
JSKIA0051ZZ
JSKIA0054ZZ
JSKIA0055ZZ
JSKIA0052ZZ
JSKIA0056ZZ
BRM-22
< REMOVAL AND INSTALLATION >
[FOR USA AND CANADA]
REPLACEMENT OPERATIONS
• Front pillar butt joint can be determined anywhere within shaded
area as shown in the figure. The best location for the butt joint is at
position A due to the construction of the vehicle.
• Determine cutting position and record distance from the locating
indent. Use this distance when cutting the service part. Cut outer
front pillar over 60 mm (2.36 in) above the inner front pillar cut
position.
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit the service part to be accurately cut at the joint position.
• An example of cutting operation using a cutting jig is as per the fol-
lowing.
1.
Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2.
Align cutting line with notch on jig. Clamp jig to pillar.
3.
Cut outer pillar along groove of jig (at position A).
4.
Remove jig and cut remaining portions.
5.
Cut inner pillar at position B in same manner.
PIIA0150E
JSKIA0104GB
JSKIA0105GB
PIIA0153E
REPLACEMENT OPERATIONS
BRM-23
< REMOVAL AND INSTALLATION >
[FOR USA AND CANADA]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Radiator Core Support
INFOID:0000000009718045
Hoodledge
INFOID:0000000009718046
Work after radiator core support is removed.
: Vehicle front
Replacement parts
z
Side radiator core support (LH)
JSKIA0523ZZ
BRM-24
< REMOVAL AND INSTALLATION >
[FOR USA AND CANADA]
REPLACEMENT OPERATIONS
: Vehicle front
Replacement parts
z
Lower front hoodledge (LH)
z
Lower rear hoodledge (LH)
z
Upper hoodledge (LH)
z
Hoodledge reinforcement (LH)
JSKIA0524ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст