Nissan Murano. Manual — part 753
PREPARATION
FAX-7
< PREPARATION >
[2WD]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009717890
The actual shapes of Kent-More tools may differ from those of special service tools illustrated here.
Tool number
(Kent-More No.)
Tool name
Description
KV40107300
(
—
)
Boot band crimping tool
Installing boot band
KV40107500
(
—
)
Drive shaft attachment
Removing drive shaft
KV38107900
(
—
)
Protector
a: 32 mm (1.26 in) dia.
Installing drive shaft
ST35271000
(
—
)
Drift
a: 72 mm (2.83 in) dia.
b: 63 mm (2.48 in) dia.
Installing support bearing
ST17130000
(
—
)
Drift
a: 32 mm (1.26 in) dia.
b: 60 mm (2.36 in) dia.
Removing support bearing
ZZA1229D
ZZA1230D
PDIA1183J
ZZA0701D
ZZA0836D
FAX-8
< PREPARATION >
[2WD]
PREPARATION
Commercial Service Tool
INFOID:0000000009717891
Tool name
Description
Power tool
Loosening bolts and nuts
PBIC0190E
FRONT WHEEL HUB AND KNUCKLE
FAX-9
< PERIODIC MAINTENANCE >
[2WD]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
PERIODIC MAINTENANCE
FRONT WHEEL HUB AND KNUCKLE
Inspection
INFOID:0000000009717892
MOUNTING INSPECTION
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.
WHEEL BEARING INSPECTION
• Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of
wheel bearing.
• Rotate wheel hub and bearing assembly and make sure there is no unusual noise or other irregular condi-
tions. If there is any of irregular conditions, replace wheel hub and bearing assembly.
Standard
Axial end play
: Refer to
FAX-10
< PERIODIC MAINTENANCE >
[2WD]
FRONT DRIVE SHAFT
FRONT DRIVE SHAFT
Inspection
INFOID:0000000009717893
• Check drive shaft mounting point and joint for looseness and other damage.
• Check boot for cracks and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occurs from drive shaft.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст